I'd be sorting all the rot out underneath if I owned it, the back axle looks like it's ready to give way any day. Great job mapping though 👍

@justinlawson1282

Жыл бұрын

I’m having my torsion beam replaced, mine looks the same as that one, can only afford to spend my money in one place… underneath !!

Champ white, love the banter. Nice bit of power. I missed Rich to 🤣🤣

They all this rusty underneath? Was thinking about buying one maybe not now

Is that the baffles coming out on the run down?

@DynodazeHondaTuners

Жыл бұрын

No just burs as all brand new

Curious boys the tegiwa 70mm 421 mani good mani, but they do the cup race mani we 100 cell cat but it says 76mm? Is that right or they the same size?

@DynodazeHondaTuners

Жыл бұрын

That would be 3 inch

We do care

Would you recommend the tegiwa 70mm over the milltek 76mm? Running from a tegiwa 4-2-1.. I’m just gathering parts atm before I book in for a remap with you guys Tegiwa 3” air intake Fd2 rrc Tegiwa 4-2-1 And ether the 70mm tegiwa or the 76mm milltek ? What for to figures would we be looking with these ? Depending on the exhaust you recommend? And would be fitting some 410cc injectors be beneficial? Thanks

@DynodazeHondaTuners

11 ай бұрын

hey buddy for power yes the 3 inch but for the money the Tegiwa 70mm is well worth it. fitting RDX injectors if your fitting cams. if you look at my video after the RRC i have cams and have got 243bhp on a japspeed manifold and tegiwa 70mm

@ears182

11 ай бұрын

@@DynodazeHondaTuners Ok thanks for the reply mate, ye I was planning on putting cams in, just trying to figure out what ones to put in and if I need to do the springs and valves at the same time, Iv watched all your videos so Iv been trying to pull out what parts are working best for the mid range performance, there was a dyno run of an fn2 doing 259 with cams and 410 injectors but it wasn’t listed what cams he had, and from all your videos the rrc inlets seem to be the ones to go for, I was looking at some velocities stacks that fit in the oem fn2 inlets ? Have you mapped any that you know have had them fitted on the standard inlet and noticed anything close to what the fd2 rrc would produce? Thanks again for the reply much appreciated

@DynodazeHondaTuners

11 ай бұрын

stick the the same as me Drag Cartel drop in cams i really rate them@@ears182

@DynodazeHondaTuners

11 ай бұрын

you dont fit cams with standard inlet you would potentially lose power@@ears182

Champ what

Pops and bangs is GTI kak, let's talk power...do you fools know Shaun Zurich?

@DynodazeHondaTuners

Жыл бұрын

What’s that sad sack? Does your mom know your using the internet?