Goodjob..... Thx's for your sharing..... Ilike it .... Keep your spirit......from Indonesia....

@idealinstitutealigarh

12 күн бұрын

Thankyou so much 👍❤️

Hello, I am an electronics engineering student, thank you for the tutorial, for me it is easy to understand and can be put into practice. But of course expectations were not as beautiful as reality, when I tried it in practice tin is quite difficult to melt and some lines on the PCB are also lifted into the type c port. I don't know if there is something wrong with my technique, because soon there will be a licensing exam and one of them is removing and installing the USB type C port and also the 3.5mm audio jack. I hope you can explain a little more about the correct technique. (My teacher gave an example of removing the object from the bottom, so it is given flux then heated and then pulled or pushed down, which is very different from your technique)

@lupi3079

Ай бұрын

Initially I used a setting of 300° for heat and 1 for wind, but because it felt less effective my friend increased it to 400 and 3.

Me encanta estas reparaciones 😊

@idealinstitutealigarh

Ай бұрын

Thankyou