Although I am not going to use it as a character background, this is amazing!

@RockoRobotics

4 жыл бұрын

Thanks!

Great video, just what I was looking for.

@RockoRobotics

4 жыл бұрын

Thanks. I'm glad it helped.

Cool video, would be nice to see the printed part at the end. Keep up the great work.

@RockoRobotics

4 жыл бұрын

Did I forget to show that? My mistake. Sorry. The brick wall behind Dogmeat in the thumbnail is the actual printed piece from the tutorial. I think I printed that one at .1mm layer height, but it was printed with one of the sides of the brick laying on the print bed.

Great, thanks a lot!

When the second layer of brick was created, the offset didn't take into account the mortar, so the offset is skewed left rather than center

great video i literally fallowed every step to the end and will make everything in brick like this cause i just started in 3d design i used to be in construction so your math on how tall and wide bricks are is off a brick on its side like when you lay them in construction are about 7.5 long or wide and 2.5 tall in inches not counting about a half inch of morter you said a quarter 0f inch tall i think you just missed the . in your notes like 2.5 or 25 as a quarter either way 4 high is a foot and 3 long is 2 feet and the average story wall is 13 or 14 feet high and how ever long with many variations none of which being a quarter inch... in all sincerity thanks alot though great tutorial .

@RockoRobotics

4 жыл бұрын

Thanks for the details on wall sizes. That will be helpful when modeling something else along these lines.

when I go to select the bricks I can not select them singly they all select together did I miss something 9:46

@kennethturney9203

4 жыл бұрын

NM ur in edit mode, sorry still new 8P

@RockoRobotics

4 жыл бұрын

@@kennethturney9203 No problem. I tend to jump past some of those kind of steps quickly. It can be quite easy to miss that kind of thing.