Building a Forged 4.6l 2V!
Автокөліктер мен көлік құралдары
Today we assemble the Birds Fully Forged 4.6l 2V! This combo should be good up to 800hp but im sure we'll lean on it!
Remember to Subscribe and Bang that Like Button!
Build List
-Diamond Competition Pistons
-MMR Forged Hbeam Rods
-Stock Crank
-King Bearings
-Arp Studs throughout
-Ported Heads
-MMR Stage 3 Turbo Cams
-Supertech Valve springs
-OBX Headers
-Edelbrock Victor Jr. Intake
Social Media.
devinbauguess
/ chiefdbo
Пікірлер: 14
I just remembered about this channel, I wondered why I wasn’t seeing any of your videos, then I realized I didn’t have all notifications on.
ok but you have the NPI engine right. so how did you mod the throttle body cable for th Pi intake man. Also what else did you had to do for the NPI to work with this engine?
Idk if you’re familiar with Richard Holdener or not, but he has some dyno vids of pre PI bottom ends with ported and cammed PI top ends that make over 400hp N/A. Pretty close to what early stock coyote’s were making. I’ve personally saw early 4.6 4 valves go fairly deep into the 5’s 1/8 mile with forged bottom and a turbo. There’s a lot of potential in these little engines.
@ChiefDbo
Ай бұрын
Love watching his stuff. I used a lot of his info for my engine.
Did you really have to use a half inch breaker bar and grabbing it at the end to turn the motor over?I’ve never heard of the spring company. Are you Springs from overseas? Did you have them checked before you installed them? The only job that the ratchet mechanism you ground the three teeth off does it hold tension on the chains with the engine off. Oil pressure is what puts pressure on the tensioners. The only way to drop the tension is to drop oil pressure.I’d be more concerned about keeping the bearings in the bottom end than wearing out the guides
good vid, now you got me thinking its possible to build mine. high comp high rpm N/A one
@ChiefDbo
Ай бұрын
Definitely not hard. I'd go for it!
nice stuff to tinker with that isn't the... tiller case on the tractor? that some Columbian put a pot metal bearing in... now it's a 4 inch ford with a 14 time higher load ratting. 4k in bills that can just pop up... keep the spare parts floating around? "recycled 8.8 because I.R.S."
Can you help me build one
@ChiefDbo
Ай бұрын
Facebook @devin bauguess
How can I contact you
@ronnieboucherthecrystalcraftsm
Ай бұрын
THE NUT HOUSE !
@leondavis3451
Ай бұрын
What’s the nut house
@leondavis3451
Ай бұрын
@@ronnieboucherthecrystalcraftsm what’s the nut house is that an engine builder