Hey Alan. Great presentation, and great project- thanks. Reassuring to see that even you make the odd mistake!

Great presentation, as allways, Alan. Thanks for haring.

Alan, you're brilliant

Dear Alan, This was a great project & most pertinent to us with workshops. How about doing a series about you outfitting your new workshop using all of your wonderful Bosch tools including some Alan Holtham special tricks. I sincerely hope you'll consider my suggestion. Hope to see more projects that are a bit bit more intricate if at all possible. Keep up the good work. Yours sincerely. V. Krapotkin.

@saporob

8 жыл бұрын

+Vladimir Krapotkin He is no more sponsored by Bosch...

@toolsconsumables7055

8 жыл бұрын

Well no one's perfect. Alan did also did promote Mafell tools. In any case Alan can always do this entirely on his own without any support from third parties ( although I'll admit it does help somewhat). Given his talent, I am sure Alan could come up with something mighty interesting. I look forward to seeing something new & refreshing. All the best to you Alan.

Very good. I'm going to make one! Thank you.

Thank you very much, i will try to do one!

Alan ,great job .Just wondered what draw runners you actually used and where to purchase them from .cheers

Plan cutlist is not correct on facebook ! Back panel is 4mm on the drawing and video . On the cutlist 18mm ..so false top will be 14mm to short then .. Also de drawer fronts are to narrow ( same witdth as drawer buttons ) so there wil be a gap of 12mm at each side ..instead of 1 or 2 mm ..the should be about 468mm wide in stead of 445mm ..