Your daughter did a great job 👏

Haven’t even watched the video yet but this is the info I’ve been looking for. In the process of going 35 spline, 4.88s and ARBs on my Sport S

@c130aviator

4 жыл бұрын

Its awesome. Good luck

@mprandazzo90

4 жыл бұрын

TewlTalk , What front axle shafts did you end up with. I’m still watching through the vids. Great content

awesome DIY!

Just want to say thank you for doing this!

Great video as always. Thanks for making it

Do you remember what bearings and axle seal you used? If you have the part numbers still that would be awesome.

I have question: JT rubicon has wide axle, is that mean wide shaft or wide axle tube? Because when I looking for chromoly shaft for my JT overland, the website shows that shaft only work for JT rubicon.

so do you know if an ARB RD245 will fit in the front of a Mojave?

Hi finally I have the time to do the rear differential, I have removed just one side of differential and compared both shaft in your video shows that the original shaft its a little short that the 35 splines one. Comparing mine its the same way if I measure from the top of bearing sleeve to the end of the shaft is 28 3/8 inches and the 35 spline is 29 1/16 in. Now I’m undecided if I should proceed.

@c130aviator

3 жыл бұрын

Reach out to where you bought them from and verify. Mine were the same length.

@edwintorres5850

3 жыл бұрын

Thanks I got in touch with ECGS with Chase and Jon. Sent them pics and measurements they decide that the new axle shaft were for wide dana differential and quickly sent me a return label and they will be sending the correct ones, the shaft are on their way back to ECGS already. I want to mention that customer service of ECGS is outstanding I’m glad to be buying from them. Thanks to you as well.

By any chance do you have the part # for the 35 spline axle shaft? The east coast supply site its kind difficult to navigate thru. I’ m trying to do the same set up for my Gladiator Sport. Thanks very much for your tutorials that are very helpful 👍

@c130aviator

3 жыл бұрын

You'll have to call them. They ordered these so they may have the part. I was the first to run them so they might be prototypes.

@edwintorres5850

3 жыл бұрын

Already got de ARB 246RD locker and the 35 splines axle shaft will arrive on wednesday but the shipping paperwork says 35 spline tow max shaft and mine it’s just a JT Sport now I’am not sure if it works 😬

@c130aviator

3 жыл бұрын

@@edwintorres5850 I hope you called them and worked that out! I was on the phone with East Coast Gear Spply for a while to get all the details. They did awesome and got me exactly what I wanted. It really is a miracle. LIke I stated earlier, I was the first to try it. So I lucked out and East Coast Gear SUpply has my business forever!

How do you go about ordering this setup? I have the m200 rear end but eventually I’m going to switch to the m220 non rubicon axle.

@c130aviator

4 жыл бұрын

Researched. Covered it in my previous videos. Then made phone calls to hunt down all the parts.

@matthewpreciado9949

4 жыл бұрын

TewlTalk okay cool, I’ll check those ones out. Thankyou

Do you remember what bearings and axle seal you used? If you have the part numbers still that would be awesome.