Boat Back Seat Rebuild - Part 2
Тәжірибелік нұсқаулар және стиль
We continue the DIY build of our back bench seat and sun deck engine cover
Boat Info: 1998 Bayliner Capri 1850 LS
Engine Info: Mercruiser 3.0L Engine Inboard / Outdrive (I/O)
Watch the Entire Restoration from the Beginning:
1998 Bayliner Boat Restoration Videos: • 1998 Bayliner Restorat...
Contact Info:
Email: zachsgarage1@gmail.com
Instagram: _zachsgarage
Music Credits:
Song: Call The Shots - Slynk
KZread Audio Library
Song: Acid - Jeremy Black
KZread Audio Library
Song: Stranger In the Way - RAGE
KZread Audio Library
Пікірлер: 20
Bro I love your videos I just recently acquired an 85 Bayliner project boat can't wait for my son and I to dig into it
@ZachsGarage1
4 жыл бұрын
Thanks!
You’re full of great ideas!!!! That seat is really looking good.
Looking forward to the next video ! Great work man !
Another great video! Love them!
This is a project that I would love to tackle…if only I actually had the skills. Well done.
Great video as always 👍
Great video, can't wait to see how this turns out.
@ZachsGarage1
4 жыл бұрын
I can't either! 😉😝
Great idea for the badge you should split the bench in half and move it back then put a engine covering over then it would look closer to a Bayliner inside but you have a great idea
@ZachsGarage1
4 жыл бұрын
Interesting idea
SmAsH that like Button!~ Genki job fam
Good job! Are you using marine grade plywood and sitka spuce along with brass screws or copper staples?
You did it! That was the only thing different than mine other than the motor. Hey i seem to be having a fuel pump problem. I think anyway lol. Can you tell me.if you have 12v at the pump when you turn the key to on? Mine only shows 10.5 when i turn it over. Was told should be 12v when switched to on.
@ZachsGarage1
4 жыл бұрын
I actually have no electric pump on my model. The pump is powered off the cam shaft and that's it 🤠
@MadPropsMakes
4 жыл бұрын
If its a mercruiser, you should only have voltage while the key is turned to the crank position, it gets voltage from the starter during cranking. After the motor is running, it gets 12v from the purple wire that runs through the oil pressure switch, so once the motor has oil pressure while running, it will supply the fuel pump with 12V. Its not that uncommon to have a little low voltage to the pump while cranking because the starter takes so much power.
@Rampage00769
4 жыл бұрын
@@MadPropsMakes Ok so i unhooked the fuel pump from carb and bumped it over and no fuel came out that was why i thought it was the pump. Also took it off altogether and put 12v to it and it runs but sounds a little noisey. So idk? Def a sparatic fuel problem as its been started twice before and ran.
@MadPropsMakes
4 жыл бұрын
@@Rampage00769 If your getting voltage to the pump during cranking, and you verified it works on the bench, then you might have a bad antisiphon valve or a clogged fuel line.
RIP Mutton Chops @5:09
Get a better name, "zach's garage" needs a bit more zip bruh.