BMW R1200GS FINAL DRIVE BALL BEARING ASSEMBLY PART _ 2
Жүктеу.....
Пікірлер: 15
@erikdalgaard70532 жыл бұрын
When pressing the axle through the 6013-2rsr (big bearing), you need to support the inner race of the bearing on the backside with a metal tube. Otherwise, the balls receive the full force of the interference press fit. While this may be fine in some instances, it is generally not good practice to have the ball bearings receive the assembly pressure.
@user-lk7ch8hf4n3 жыл бұрын
שאפו, ההשקעה ניכרת בכל שלב ושלב.
@ducky14963 жыл бұрын
Nice Job!!! Thank you for making this.
@motorradler1982 Жыл бұрын
Thanks, Great Video
@user-cm3ul9jj3m2 жыл бұрын
Сразу видно человек знает что делает👍👍👍
@iribertomuller78686 жыл бұрын
thanks about these instructions, it was very important to me.
@Drtikol694 жыл бұрын
super video ----díky
@TheDervMan6 жыл бұрын
Nice press 👍🏻
@adrianbunaciu77232 жыл бұрын
👍
@msdmotorbandenserviceSprundel6 жыл бұрын
which parts did you renew beside the 2 bearings
@stuaralejadrocruzcruz8866 жыл бұрын
xk no hay ningu video de como en rayar un rin de bmw r1200 gs y aliniar
@Neputkatnesem6 жыл бұрын
but waht was defect? Lager?
@Wildezone2 жыл бұрын
How much you do that if i asked you to do it for me
@Gatto20406 жыл бұрын
ottimo lavoro peccato per la qualità video
@joeltyner23534 жыл бұрын
Looks like you installed the large oil seal in the opposite direction of the one you replaced; has it held up ok?
Пікірлер: 15
When pressing the axle through the 6013-2rsr (big bearing), you need to support the inner race of the bearing on the backside with a metal tube. Otherwise, the balls receive the full force of the interference press fit. While this may be fine in some instances, it is generally not good practice to have the ball bearings receive the assembly pressure.
שאפו, ההשקעה ניכרת בכל שלב ושלב.
Nice Job!!! Thank you for making this.
Thanks, Great Video
Сразу видно человек знает что делает👍👍👍
thanks about these instructions, it was very important to me.
super video ----díky
Nice press 👍🏻
👍
which parts did you renew beside the 2 bearings
xk no hay ningu video de como en rayar un rin de bmw r1200 gs y aliniar
but waht was defect? Lager?
How much you do that if i asked you to do it for me
ottimo lavoro peccato per la qualità video
Looks like you installed the large oil seal in the opposite direction of the one you replaced; has it held up ok?