Thank you for replying.

Manual says 6-7cfm air compressor and you ran it no problem with that 2.6cfm air compressor?

@dc_andrade

3 ай бұрын

Hello, it did run pretty good. I assume with a bigger tank you have longer runs on your cuts. I did notice the air supply run low after non stop use. I should have probably mention that in video. At one point I did have to wait for the pressure to build back up. Hope that makes sense!👍👍

Brother please respond to my comment about your extension cord on the generator I can’t find one at any of my hardware shops

@dc_andrade

Ай бұрын

Hello, sorry I tend to miss a few comments every now and then. Are you talking about the extension cord adapter for the 220v weld machines?

How do you find the compressor with the Bestarc. Was it sufficient?

@dc_andrade

Ай бұрын

Hello, thank you for the comment. The size compressor in using was sufficient enough for at project cuts. If your looking for longer timed cuts I would recommend a larger capacity compressor. I could get maybe like two good 1min cuts then I would have to wait for the compressor to fill back up. Hope that answers your question. 🙏