Bernette 610D Serger / Overlocker Servicing - with Before and After Comparison
Тәжірибелік нұсқаулар және стиль
This Bernette 610 serger came in for service and my customer mentioned it was noisy, even though its near new. Apparently it was an ex-demonstration model but had been serviced prior to being sold to my customer.
I show how to remove the covers to gain access to the interior workings and how to clean and lubricate the machine.
I also show side by side comparisons of the before and after service to compare the general running of the machine.
Cleaning and lubrication is the main focus of this video. I don't cover other subjects such as blades and belt tension or general troubleshooting.
Please consider supporting the channel at Patreon - / sewingmachines
Web Site - www.institches.co.nz
Details of subjects covered are listed in the index below.
Index/chapter list:
0:00 - Introduction
0:32 - Testing the machine threaded
3:28 - Testing the machine un-threaded
4:25 - A look at the swing out front
5:32 - Removing the needles
6:47 - Removing the covers etc
17:45 - Discussing cleaning
18:30 - Lubricating
31:42 - Assembling the machine
43:00 - Installing needles
44:10 - Aligning the throat plate
45:05 - Fitting the presser foot
45:40 - Noise comparison test before & after service
47:46 - Noise comparison with the machine threaded
48:54 - Conclusion and thanks
Пікірлер: 3
The magic sound of an oil drop ! Thank you for this good sample and the quality of your video.
Oh yes. I noticed the difference immediately. Very nice. Thank you!
Impressive difference! Thank you!