Bruh the second you said “oh just dropped a bolt in the motor” I was like wtf did he just say, like my heart dropped for a second😂😂😂

Please put out info on rtv oil pan. Great video

So lower grade means they are smaller and higher number it means they are bigger? Or opossite? Or is it in different grades for some other reasons?

Did you measure the temp difference between the two that were 0.0002" different? May only be 0.0001"! 😁 That's some fine tolerances. When this is done... What's your overall opinion on this engine? It seems Ford is walking a fine line with a lot of room for error..IMO. Great video... Waiting for the next!

@mt1885

4 жыл бұрын

JUNK - disposable turbo weed eater engines that cost more than the truck is worth to fix

@micahap1559

4 жыл бұрын

@@mt1885 😆... I'll have to use that to tease! Weed eater ..

@mt1885

4 жыл бұрын

@@micahap1559 haha It is true, gimick engine with 2 turbos, the electronics from a nightmare, disposable plastic all over, horrid designs (as they change it constantly) as they are being 'tested' by people who believe marketing. Resale is terrible like gas turbos from the 80's they all end bad.

could this be because of high viscosity oil used and/ or just overloading the engine

@CrazedPerformanceRepair

2 жыл бұрын

Are you referring to the bearing tolerances? These actually don't use thick oil. I believe they call for 5w20 from factory if my memory serves me right.

Cam-chains in those eco-toot engines must be made from scrap metal. Look like they will stretch looking at them. HORRID designs and all marketing until it breaks.

I was hoping you video would give me more details on the thrust washer placement,I'm trying to rebuild my friends 3.5 EcoBoost it's the first time I've ever attempted such a project but I don't feel it's beyond my I have a Haynes manual which is fairly detailed and I also have Service manual , when I tore the lower half of the motor out hey if you anyway I do recall three thrusts washers coming out of and when I bought new bearings for this motor it came with three thrusts washers as well had no problem getting the back to in it's just I have one left over for the front and I can't for the life of me figure out where it goes can you help me with that and anyway I would greatly appreciate it

@CrazedPerformanceRepair

10 ай бұрын

Perhaps I can help you via PM on my website. That or joint premium membership on my website and create a premium forum post about it. Then I will definitely share all the information requested and more. I have full factory service manual availability. I will end up posting PDFs, pictures, and the whole nine yards when requested.