Learn how to Install the Baby Jogger® City Turn™ Convertible Car Seat in Rear-Facing mode using the lower anchor attachment by watching this quick video. First, make sure that your car seat is ready, then adjust your car seat's recline foot to the rear-facing position until it clicks into place. Next, remove your lower anchor attachment and all straps and connectors from the storage area in your seat. Close the storage door and now you’re ready for the car.
Place your car seat rear-facing in the vehicle and slide it against the back of the vehicle seat. Make sure that the base of the car seat is flat with the vehicle's seat and that you are in the correct blue zone based on your child’s age. Squeeze the lever at the front to rotate your car seat. After, press the grey button in the back of the base to open the lock off. Next, grab the vehicle’s lower anchor attachment and place it in the belt path through the blue line underneath the lock off. Attach the lower anchor connector to the lower anchor in your vehicle on both sides. Then, press down on the seat and tighten by pulling on your anchor straps to secure the seat. Close the lock off and click it into place. Recheck for tightness and your blue indicator. Lastly, adjust the headrest to the proper position for your child, then remove the infant support if you’re not using it and store them away. Now you’re ready for baby after learning how to install your City Turn ™ car seat using the lower anchor attachment.
Have any questions about the City Turn™ Car Seat? Please visit: www.babyjogger.com?BabyJogger_20210924_SEO
#babyjogger
#cityturn
#carseatinstallation
#rearfacing
#convertiblecarseat