Shout-out to TeezyThaKidd thanks for your opinions and suggestions!
Жүктеу.....
Пікірлер: 5
@TeezyThaKidd Жыл бұрын
Epic! This is exactly how I ended up getting them on, too. Even without the adjusted print (which I haven’t printed yet anyway) I am more than confident that these will far exceed my expectations! I can’t wait to print the other two guards (OG print) lmao
@Unit2020 Жыл бұрын
Hey TechTacTool - I'm new to 3D printing. After seeing your video on Fitting Issues, I was thinking I'd load the .stl file into TinkerCad 3D and cut out a little slot for the screw heads before I send it off to be printed. After importing it into TinkerCad, to my surprise the channel for the motor arm itself is 14mm. Yet, I got out my micrometer and measured the arm width on my Baby Ape Pro V2 and it's 10mm. Can you help me figure out the discrepancy? Is your Baby Ape a V1 and this is design change? Just wondering if you know.
Пікірлер: 5
Epic! This is exactly how I ended up getting them on, too. Even without the adjusted print (which I haven’t printed yet anyway) I am more than confident that these will far exceed my expectations! I can’t wait to print the other two guards (OG print) lmao
Hey TechTacTool - I'm new to 3D printing. After seeing your video on Fitting Issues, I was thinking I'd load the .stl file into TinkerCad 3D and cut out a little slot for the screw heads before I send it off to be printed. After importing it into TinkerCad, to my surprise the channel for the motor arm itself is 14mm. Yet, I got out my micrometer and measured the arm width on my Baby Ape Pro V2 and it's 10mm. Can you help me figure out the discrepancy? Is your Baby Ape a V1 and this is design change? Just wondering if you know.
👍👍👍 ... Link STL please
@techtactool5756
10 ай бұрын
www.thingiverse.com/thing:5897823
@coffeekreasi
10 ай бұрын
Thankyu very much