You are using your aviation snips wrong. Yellow.. for small edge cuts. Green and Red cut straight or curved. Red: the metal curls up on the left side of the cut. Green : the metal curls up on the right side of the cut. The curled side is your waste side. The good side will have a clean, flat edge with no distortion. Being spring loaded allows for squeezing 1/4" incremental cuts in repetition. The small increments allow for better control than longer incremental cuts.

@slingshotshooter7536

Жыл бұрын

i have only the yellow ones i had a lot of trouble cutting a long piece of metal roof the yellow straight cut snips doesn't curl the metal ?

@brendens5961

9 ай бұрын

​@@slingshotshooter7536I have found the yellow ones to be useless. I'd get a pair of right and left. It's a bit of work splitting a sheet(you pretty much cut it twice pushing up a small ribbon out of your way). For about the same price you could get electric sheers. Sheers only cut flat. A nibbler can do all kinds of things. The cheaper ones attach to a drill.

@firefly6880

3 ай бұрын

​ @slingshotshooter7536 ​ @brendens5961 The offset versions (red/yellow) are *much* easier for cutting long pieces. Various examples available on KZread.

Wanted to watch a video so I could stop cutting stuff like you do!

What’s the model number on the old craftsman(made in U.S.A) snips with the yellow handle?

Are there any handtool cutters that I could cut 1mm aluminum with? Or will these do the job?

@JustToolBasics

Жыл бұрын

Unless the aluminum you're cutting is very annealed, even if you managed to smash through it, it would have a _really_ rough edge since the kind of aluminum coming as a 1mm plate isn't (usually) very malleable and these tools kind of depend on that property. Aluminum generally does a lot better with a saw-type tool (or other types of tools that evacuate chips, like a nibbler or whatever) -- aluminum tends to "load up" on abrasive cutters and similar cutting tools that work fine with steel. Of course, it depends on the kinds of shapes you're trying to cut, but I'd suggest a jigsaw with a metal-cutting blade.

Which brand ? Is Stanley fatmax snip worth buying ?

@JustToolBasics

3 жыл бұрын

Wiss and Midwest brands (linked above in the description) are the two big names in snips. Both are made in the USA, both are very high quality -- I own a mix of them (basically, if I'm in the market I'll get whichever is available/cheaper-at-the-moment). The Stanley FatMax snips have pretty high reviews, so they don't seem terrible, of course, but I personally don't feel compelled to switch brands, either. They are made in China, if that matters to you, as well.

"Well, I kinda mangled that a little bit..." Ya think???

Agree with Ray barn, your using and explaining wrong!