Tbareklah 3lik a khoya

@strictlyaudis7012

3 жыл бұрын

شكرا جزيلا

Did you calibrate using obd scanner cam/crank relearn?

So the hole you showed at 2:00 is that where the sensor goes? If so how did you plug it in?

U ever had a problem with the 395 relay under the ecu

Question: my car 1999 1.9 tdi 110 started faster then most petrols, however I had this trailed to a new location and it’s never ran right since, air lock, bleeding the fuel lines to try and get this to start, nothing one thing I do notice the Rev counter doesn’t move when turning over and the diesel doesn’t shoot out the cracked open injectors ? Could this be a broth fuel pump? Thanks

@strictlyaudis7012

3 жыл бұрын

Never worked or had a diesel car, if I tell you anything, it will be a lie hhh sorry . I’ve been wanting to have a diesel one just to know more about diesel motors but at the moment sorry I couldn’t help

Same problem I think showing only misfire codes though p300 and changed sparks and coil pack still same codes there

I got a Chevy manifold pipe on mine as well

So I got an 11 Quattro. Had the crank no start issue but would try to catch and would barely run for a couple seconds. Now when I try to start it, it doesn’t sound at all like it has any kind of combustion. Sounds like the motor is turning over without any load very quick rather than a slow kind of cranking noise. Any idea?

@hbkkayson1456

Жыл бұрын

Broke timing belt or timing belt pulley replace it and check to make sure you don’t have any bent valves

👏👏👏👏👍💯💯💯

I have an Audi A4 and at first it was just cranking and wouldn’t turn over but if I gave it gas while cranking it was able to turnover but it was shaking and the engine light started blinking I drove it in circles around a parking lot to see if it would get better and it didn’t and when I parked and turned the car back on there was no crank and it didn’t turn over just the battery was working

@anthonyjohnson9710

3 жыл бұрын

Do you think this is the crankshaft sensor ?

@strictlyaudis7012

3 жыл бұрын

It could be the crank sensor but also I’m thinking you had dirty injectors and or bad coils . I would check the coils , injectors and the crank sensor . Plan on doing a big job on it not just scratching the surface . What year is it and what engine ?

@martinee4901

3 жыл бұрын

Check it with a OBDI, even a real cheap one. It will bring up the specific P# code for Crank sensor. My B6 one went bad suddenly & my cheap OBD1 told me that too. It worked ok under 50°C but went bad over that. Engine light stayed on once it was triggered, only drove it twice when it went bad anyway. Cheap easy fix.

@enlightenedmcgee

3 жыл бұрын

Same. Exact. For me. Is it fixed now? Please tell me what was wrong

Hi, can this sensor caused a sudden stall at a red light?

@strictlyaudis7012

2 жыл бұрын

Yes , that’s what it does most of the time or after you park then want to drive again

@bcampbell611

Жыл бұрын

Yes

Thenk you

Do you have any idea why an Audi fans don’t start but after I take out a fuse they go 100%

@strictlyaudis7012

Жыл бұрын

I have a vedio for that , look at my first vedios

@blacklotus432

Жыл бұрын

@@strictlyaudis7012 nice

my audi a5, went from 140km to 50km at highway and didn’t go higher. and after i stopped the car it wont start again. car want to start but nothing happpening. is it the same problem?

@strictlyaudis7012

Жыл бұрын

Same problem just happened to my q5 , your car jus like like mine was consuming oil more and more till it stopped running :solution : engine tear down , piston ring job must be done or engine replaced

Similar problem but my solution was that my EFI and ECM relays were bad.

@adriandeleon392

2 жыл бұрын

What’s the Efi relay ?

@adriandeleon392

2 жыл бұрын

Fuel pump relay ? 70 amp?

@b_rabbit435

Жыл бұрын

It's a common problem that the seal breaks or gets missalligned on the ECM box and water gets into the box which will kill the two relays under the computer. I had this problem and had to swap relays multiple times because of water kept getting into the box, sealing the box properly is not the easiest so I suggest finding a new lid with seal. Eventually i had to swap out my ECM as it was water damaged.

Endo de va?

It doesn’t generate power it only interrupts power

What about the camshaft sensor

@strictlyaudis7012

2 жыл бұрын

That is not the first thing I would check and I’m not sure it will cause same problem, simply I haven’t seen that happen

@BNBSanchy

8 ай бұрын

I had a code for camshaft position sensor, no start issue. Replaced it and no longer have the code visible but still no start.

☝☝☝☝☝👏👏👏👏👏

Car cranks and runs but only for 10-15 minutes??

@bilalomar8254

2 жыл бұрын

Hi m having samw problem did you find any solution

@diegoromo8430

Жыл бұрын

Did you ever figure out what it was ? @viper.

Your vedio you mention this might be. I feel you need to mention the engine components by name so that we will know were you coming from otherwise thanks for the vedio

@strictlyaudis7012

Жыл бұрын

I think the last time I checked I found out that I don’t work for you , you need to teach yourself some manners , respect and appreciation, be thankful that someone made all that effort to make this vedio possible , people like you who made me stop posting more vedios . You don’t deserve my time and effort.

@strictlyaudis7012

Жыл бұрын

Pho Q , i don’t work for you ,

Did your car turn over and start up sometimes, or was it just dead. My sometimes takes a long time to start. Any ideas have to crank motor for 30 to 40 seconds to start . It is to fire right up

@strictlyaudis7012

3 жыл бұрын

My car would just crank but never starts till I replaced the crank sensor

@umarj3461

3 жыл бұрын

Was your issue crank sensor?

@lizards7777

3 жыл бұрын

No they said at Audi that it jumped timeing, but now my chk. Eng. Light just came back on but the car works good

@AngelRodriguez-jv6oc

2 жыл бұрын

@@lizards7777 so it jumped timing was that easy fix can it turn on ?

@adriandeleon392

2 жыл бұрын

@@strictlyaudis7012 I need some help on Audi a 4

It’s OBD 2 not 11 and saying this in good sense, not to make fun.

@strictlyaudis7012

3 жыл бұрын

I totally get it but this is OBDeleven ultimate , it’s called that way . It’s made in Lithuania , there is starter, basic, pro and ultimate. And it’s called OBDeleven. Type this word in your phone and you’ll see the app :) I’m saying this to you in good sense as well not to make fun of you. Thanks for watching , the vedios that are coming next will be really good ,

Hey, I would like to know what Pxxxx code you got with OBDII, got the problem 3 days ago with 1.8T 225HP my daily, and it was starting right for 5 minutes in the morning , turn off and it won’t start after all later!

@strictlyaudis7012

3 жыл бұрын

I don’t really remember but the code sent me directly to the crank sensor , Try to put a new crank sensor to see if the problem is gonna go away . Also see if the rubber tube coming out of turbo if open or cut , if it’s open the car will crank but won’t start

@strictlyaudis7012

2 жыл бұрын

@@jimmyjames8164 I know that but I have so many cars in my OBDeleven scanner and sometimes finding the right one is a hustle

@wlin0075

2 жыл бұрын

P0016