Hello, where can I find a video where I pointed out how to do it in a 2012 because I already looked and did not find it, could you make one ???

even with it deleted 170 should be normal temp without restriction, btw transmissions get hot quick!

Im in Az so not to worried about cold temps but is there a temp that would have the trans running to cold, thus having a negative affect and this would not be recommended? I've always been told you want trans temp above 100 degrees (considered warmed up temp) before you get on it. Thanks

Do you recommend a trans fluid ,brand, synthetic ?

do u lose tranjy fluid while doing it ? I just don't wanna be too short or too much cause there no way to check it

@jacknicholson5794

3 жыл бұрын

Just catch it in a clean pan and put back in what comes out

do they make this for 8hp75

If my aisin is consistent at 160-170... should I add this will it make the fluid to cold ? I do hotshot pulling 20k .. Thanks

@mcombsemail

4 жыл бұрын

It sounds like your stock bypass is working perfectly. 160-170 is excellent. The porridge is just right!

Is this for the 8 speed automatic my 2014 hemi is overheating and dealer can't find the issue

@00mrvip00

3 жыл бұрын

Look up hellraisers 8hp70 bypass valve, same thing just different company.

I had 170-180 degree trans temps consistently, summer or winter. Now, with the block installed I can't get over 130 during the winter.

@FOEKING-zv4su

2 жыл бұрын

Is that bad ?

My tec transmission pan install

Why only for the 13-19??? I have a 2012 and live in Tenn, boy I need all the cooling help I can get

@MrFlyG3

5 жыл бұрын

Kenny B I believe the pre-13 trucks do not have that valve. I have a 2012 with Max Tow package and I don’t have that valve.

@coreyadams4646

4 жыл бұрын

Yes your part number is part# 68rfe-tc-tbu-2, google it , its $79.00 at Rudys Diesel. Located near the fuel and water separator on the truck.

@fuser1994

3 жыл бұрын

@@coreyadams4646 dude i feel like a dumb bitch because that’s exactly where I am looking but no luck

@coreyadams4646

3 жыл бұрын

@@fuser1994 Ebay has them, www.amazon.com/Transmission-Thermostatic-Upgrade-Compatible-2010-2012/dp/B083TNXFFN

@coreyadams4646

3 жыл бұрын

Amazon also

Turbo rubbes a hole right through the line.

@wesleywhittington8499

2 жыл бұрын

Too close to the turbo plus heat.

Can't you just take out check valve of the original and save $

So much bad information I'll just key in on the main points. I'm guessing you sit behind a desk because you have no real understanding of how this stuff works. 1) Transmission fluid is not thinner when cold. 2) The whole point of this product is to INCREASE trans temps. Just like the thermostat in your engine cooling system it increases minimum temp (optimal operating temp) but DOES NOT increase cooling capacity. 3) To say someone is running at 120 degrees is ridiculous and if in fact they were it means your product is defective. If your block is set to 120 degrees or lower you might as well eliminate the block all together. Maybe the stock units were prone to failure but that doesn't change the fact that everyone who watched this video is now dumber, but maybe you moved some product. Get one of your techs to do the next video.

@mattv4747

4 жыл бұрын

I think you're misunderstanding what he says, while yes he did state thinner when cooler, which is false, the idea behind this new one is to DELETE the "thermostat" from the line, therefore sending all of your fluid to the cooler, which will decrease the overall temp. It has no valve in the body like the stock one........ So while the purpose of the OE product was to increase the temp quicker, the purpose for this is to DELETE it, thus running cooler. I think he did a fair job explaining this, other than the little bit of mix up for temps and thickness.

@MrKThomas1976

3 жыл бұрын

Matt V. Exactly