The optical S/PDIF out port described in the rear panel I/O description is incorrectly entered. The optical S/PDIF header is inside, but it does not provide a separate port on the rear panel.

nice video ! i been eyeing this motherboard for months. thanks for the information !

I have this board sitting here and still waiting for a few parts, I think it looks great. Super excited to build a pc with it

Pairing this next week with an i5 12600kf, 32gb ddr5 6400 cl32 and a Samsung 980 1tb nvme.

Do you know if it's possible to enable/disable the m.2 slots in BIOS for drive isolation? Similar to what you do with SATA ports. Asking because this seems to be a rare and complex feature to implement. If you would know this with 100% certainty it would be golden. The setup looks great! Anyway nice video!

@DalraeMyo

Жыл бұрын

I don't have this motherboard at the moment, so it's going to be hard to check. If I use this motherboard again, I'll check it out.

Hi, Bro! Tommorow i will assebly pc with this mb and 13400f)!

Are you using the same CPU as in previous videos? I noticed big power consumption bump from around 80W on Gigabyte board to 99W on this board. Does it mean that Asus is so inefficient in both Idle and Load?

@DalraeMyo

Жыл бұрын

There may be differences depending on the default setting or BIOS version for each manufacturer. I'm considering changing the BIOS version.

I ve read somewhere that it supports aptx protocol but I can t find it in any documentation. Is that true?

Is there a way to undervoltage the i5-13500 on this motherboard? On the net, I only found information that this can be done by replacing the microcode with 0x104 - but I do not have this section in the BIOS. I currently have the latest BIOS version 1205 + Intel ME 16.1.27.2176 P.S I will be very grateful to you if you make a video about undervolting with this b760-i and non-k 13 gen. processor. - for many it will be invaluable information!

@DalraeMyo

11 ай бұрын

Unfortunately, I don't think there is a microcode change function in the CPU other than the K version yet. However, undervolting function was applied up to -0.05v without microcode change in Non-K CPU.

Can you tell me what is the vcore of your cpu in the bios? Have you undervolted it? I see it is pullinh 1.057V at 100W of load. Mine is a 14600 and it pulls 1.28V at 100W and in bios it is set at 1.27V which for me is a bit high.

@DalraeMyo

4 ай бұрын

The Vcore of the CPU is the voltage applied to the CPU. I've tried undervolting a few times on the motherboard of the B chipset, but I've seen that the multi-performance score is significantly lower than that of the Z chipset motherboard. However, if some microcode changes are possible on the B chipset motherboard, it is possible to offset the significant performance drop to some extent.

hello! I have the same motherboard. I wonder if the M2 )the storage on backplate), is working? because mine is not detected at all by both bios and windows. thank you

@DalraeMyo

Жыл бұрын

Make sure that the M.2 SSD you want to use is M.2 SATA storage, not NVMe storage. It may be an M.2 NVMe type that is rarely recognized.

With that cooler can you still fit a 92mm fan at the rear?

@DalraeMyo

Жыл бұрын

It will be possible if the installation direction of the CPU cooler heat sink is different.

been trying to start this board up for months, cant get it to start up, going to buy something else, im out 220. bucks

Do you think this motherboard would be good paired with 13700K? The B760-i from MSI seems to have a better VRM maybe it's better VRM. How do you think both boards compare? thanks!

@DalraeMyo

8 ай бұрын

Personally, if you're using a K-version CPU, you'd better choose a Z Chipset motherboard. This is because it can be used at a lower voltage than the B760 chipset motherboard when the CPU is under load. (Also, in Korea, the price difference between B760i motherboard and Z690i motherboard is small.)

@BornIntoThis20

8 ай бұрын

@@DalraeMyo In my country B760i are arround 200€, Z790i are 300. I can still use PL with B760 I guess. Apart from that, between Asus and MSI B760 wich one would you choose?

@DalraeMyo

8 ай бұрын

The b760i EDGE certainly had a slightly higher VRM spec compared to the b760i STRIX. If the price is similar, and there is no objection to white color, the b760i EDGE would be a good choice. The downside of the B760i EDGE is that the pin location and sound chipset of the F_Panel are ALC897. @@BornIntoThis20

@BornIntoThis20

8 ай бұрын

@@DalraeMyo Thanks, doesn't bother me as I'm using an external soundcard anyway. I'll check more of your builds videos to choose between the 13600k and 13700k regarding temps and PL/UV, still undecided and they help a lot ;) May I ask, since you tried lot of them, what AIO or ventirad cooling solution you think would be best for a 13600k or 13700k in a hyte revolt 3 with a CPU intensive usage (editing)?

@DalraeMyo

8 ай бұрын

Most AIO solutions have similar performance. I think pump OEM is important as a personal recommendation, so I recommend Asetek OEM products. (Models with 7+ Generations of PUMP) In addition, in the case of B660/760 chipset motherboards, there is a section where the CPU performance score decreases when UV is applied. (There is no CPU performance score drop for Z chipset)@@BornIntoThis20

Hi friend, I have an assembly very similar to yours. I have a problem, the AIO pump remains high even after starting the PC. Could you help me?

@DalraeMyo

7 ай бұрын

Almost all motherboards are defaulted to operate at 100% to maximize AIO performance. RPM adjustments are required in the BIOS to slow down the pump.

ASUS ROG STRIX B760-I or the Z690-I? cant decide between the 2 please help

@DalraeMyo

5 ай бұрын

If you're planning to have a lower CPU operating voltage and undervoltling, the Z chipset motherboard is good. However, the CPU cooler compatibility is very bad for the Z690-I STRX.

May i know what is the thickness of the ssd+heatsink placed at the back of the motherboard?

@DalraeMyo

Жыл бұрын

The rear m.2 SSD heatsink used in the video is 3 mm thick.

@davidyip4632

Жыл бұрын

do u thk there is still sufficient space for a rear m.2 ssd + heatsink (with total thickness 10.5mm)? many thanks !

@DalraeMyo

Жыл бұрын

@@davidyip4632 I think the panel will close if the heat sink is less than 6mm thick.

how to undervolt the 13600k with this mobo? to lower the temp in my itx build?

@DalraeMyo

Жыл бұрын

Undervolt is available on motherboards with Z chipset. Motherboards with B chipset can lower temperature with PL1/2 power limit.

bought a similar setup with the same mainboard, 12400f and 32gb kingston fury 5200 ram. i have the issue that the machine wont boot. the mainboard shows me the orange dram led. tried swapping ram etc nothing helped. any help here? tia

@DalraeMyo

Жыл бұрын

In rare cases, there may be a problem with the motherboard apart from the EZ debug LED. I think it would be better to ask the place where you purchased it or the A/S center.

@SW-xy1wy

Жыл бұрын

@@DalraeMyo yes, think i ll return it. tried every workaround from the internet

Hi! I have this mb and my pc restarts every time when I get in bios or run memtest86. What’s wrong? I checked with another ram and psu. And the same result:(

@DalraeMyo

Жыл бұрын

I've never experienced that symptom. If you have proceeded with memory overclocking, try BIOS reset. If you have such symptoms even though you did not proceed with memory overclocking, please contact the buyer or manufacturer.

Does anyone know if a stock cooler from intel fit this motherboard? Looking at this video, there is a black plastic thing on the left of the socket that might be an issue for a stock cooler?

@DalraeMyo

Жыл бұрын

I don't think there will be any Intel stock cooler compatibility issue. Even on motherboards that are less compatible with LP-type CPU coolers than this motherboard, there was no interference problem in installing Intel stock coolers.

@retsel

Жыл бұрын

@@DalraeMyo Thanks

bro, those storage sticks are same size right?

@DalraeMyo

11 ай бұрын

If you're talking about the M.2 drive, there's additional support for the standard 2280 to 2060 and the rear 2242 as well. In general, if it is not a special size, you can know it as 2280 standard. M.2 Both slots 1 and 2 support size 2280.

@zethcrane5468

11 ай бұрын

@@DalraeMyo thank you bro, much appreciated your feedback. This means if I purchase both 2280, i wouldn't have issues.

🙏🙏🙏😍😍😍😍😍👍👍👍

a 750w PSU would be enough for this build?

@DalraeMyo

Жыл бұрын

According to the system configuration, I think 600W will be enough.

Would be great to see how this board performs along the 13600k

@DalraeMyo

Жыл бұрын

It seems to be sufficiently usable in the VRM specification. The B660i of the previous generation 400A class power supply was also sufficient for 12700K use.

@Made_In_Heavenn

Жыл бұрын

​@@DalraeMyo can i do heavy games in this itx motherboard?

@DalraeMyo

Жыл бұрын

@@Made_In_Heavenn There are variables depending on the environment, but I think it's enough in most environments.

이보드는 광출력이 아쉽네요...ㅠ

Is this mobo compatible with deepcool AN600 Air cooler?

@DalraeMyo

9 ай бұрын

It's compatible.

@vivekverma3629

9 ай бұрын

@@DalraeMyo I mean do I need a VRM heatsink mod or a restricted RAM module height? Asking because this mobo has a fairly large rear IO shield and a tall VRM heatsink.

@DalraeMyo

9 ай бұрын

It could also be installed on the Z690i and Z790-I motherboards, which have larger heat sinks than the B760-I. If you mount the CPU cooler toward the VRM heat sink, there is no memory height limitation.@@vivekverma3629

@DalraeMyo

9 ай бұрын

If you are still worried, I recommend the IS-67-XT model.@@vivekverma3629

@DalraeMyo

9 ай бұрын

I understand the intent of your question. Are you right to worry that it is mounted slightly tilted due to the VRM heat shield like AXP120-X67? For the AN600, it's a little more relaxed, but it's still just right at the height of the B760-IVRM heatsink, or it can tilt a little bit. If you don't like this, there's a CPU cooler called is-67-xt.

Strix chu.

sad to hide your nice motherboard with this big fan.... no?

@DalraeMyo

Жыл бұрын

Conversely, a cooling fan can cool the entire motherboard.

@enzomichelena

Жыл бұрын

@@DalraeMyo ok thank you don't know that

노루추