Arctic cat snowmobile Ignition and Safety Switch Diagnosis - and first Start!

Автокөліктер мен көлік құралдары

I acquired a 1992 Arctic cat Snowmobile and I go thru it to see what works and what does not. and I also work on the ignition wiring & Safety Switches and the TSS Throttle Safety Switch.
Music: Happy Rock Royalty Free Music from Bensound

Пікірлер: 19

  • @alexkunzelman5825
    @alexkunzelman58252 жыл бұрын

    Thanks lew I've just gotten me a 580 Arctic cat with starting issues lol ill be digging into it tomorrow

  • @mndoing
    @mndoing4 жыл бұрын

    Keep it up and welcome to KZread

  • @LEWCANFIXIT

    @LEWCANFIXIT

    4 жыл бұрын

    Thanks!! Will do!

  • @jeffwilliams332
    @jeffwilliams3322 жыл бұрын

    The throttle bar, I am having the same issue, its a not tight. It starts if I jam something like you said. Did you adjust the cable? I see the while plastic tie .

  • @genobusa117
    @genobusa1176 ай бұрын

    Im having the same problem with my thumb throttle not tight enough to push on that internal safety without pressure on throttle. How did you fix it?

  • @Evening120
    @Evening1202 жыл бұрын

    Wait how did you fix the spark problem ?

  • @williamtomisser5312
    @williamtomisser53123 жыл бұрын

    If you dont have the key can you disconnect the ignition harness? would it start without the key?

  • @williamtomisser5312

    @williamtomisser5312

    3 жыл бұрын

    i have a arctic cat prowler about the same as this one

  • @LEWCANFIXIT

    @LEWCANFIXIT

    3 жыл бұрын

    Yes! If you just unplug the harness and put a jumper on the 2 non-yellow wires, that will allow the coil to make spark! But it also overrides all safety switches and key switch. So i recommend only doing this for testing purposes.

  • @williamtomisser5312

    @williamtomisser5312

    3 жыл бұрын

    @@LEWCANFIXIT ah ok. I just grabbed my multitool and literally cut the key hole out of the plastic body of the machine. I tried connecting the two conductors together with a piece of wire but i couldent tell if it was working (it probably would have, the main reason for all of this is the machine has been sitting for three years outside so i had to get it going) so i just hot wired the copper wires together. im going to go to the locksmith sometime here soon and get a new key and gorilla tape the key hole back into the body. Its an old machine so i wasent really very sad about cutting into it. Thanks :)

  • @LEWCANFIXIT

    @LEWCANFIXIT

    3 жыл бұрын

    Sounds good William, have a merry Christmas!

  • @richardmaaske2601
    @richardmaaske26014 жыл бұрын

    You had the button shut down . Than you pulled it up and than you had a good connection >

  • @rustynutz4493
    @rustynutz44932 жыл бұрын

    Pronounced El Tee- Gray. Hand pull only sucks but once running they are Great Sleds.

  • @davidfrank6666
    @davidfrank66663 жыл бұрын

    i would say it was the standard amount of smoke.

  • @LEWCANFIXIT

    @LEWCANFIXIT

    3 жыл бұрын

    Good to know! thank you. you just never have to deal with it unless your sitting idle.

  • @dillongates4520

    @dillongates4520

    3 жыл бұрын

    @@LEWCANFIXIT it will smoke alot until fully warm up

  • @user-or3ez4uo6g
    @user-or3ez4uo6g6 ай бұрын

    Нет искры вобше

  • @Leeer0yjunkins
    @Leeer0yjunkins6 ай бұрын

    I like the part where he shows you wtf hes doing

Келесі