I did this on an old tractor tank a few years ago. It was not POR15, different brand, but it did not work at all. Despite following the instructions exactly, I'm still dealing with the epoxy chunks peeling off inside and the rust is worse now. I hope yours works out better than mine.

@YoshimoshiGarage

15 күн бұрын

That doesn't instill confidence. I hope I have better luck as well.

@CatastrophicFarms

15 күн бұрын

@@YoshimoshiGarage I think the biggest issue was it was impossible to get the epoxy onto the baffles, so they were left untreated and I'm sure that's where the peeling started and progressed from there.

@snapon666

14 күн бұрын

same here with several M/C tanks all peeled ...interesting thing was on a split HD tank one side peeled other didn't other set done at same time by another person same product did the same ...I have a theory that the etching agent loses its strength after doing the first half

Just wondering how long it will last when exposed to fuel....ethanol and the additives they use in today's gas is the main culprit for moisture absorption.... I have done boats where I pulled over 5 gallons of water mixed in the fuel... Pure gasoline does not absorb as much water from the air as E10 or become as corrosive as quickly.

@YoshimoshiGarage

15 күн бұрын

We'll see, but it's got to be better than raw steel. I hope, anyway

@snapon666

14 күн бұрын

@@YoshimoshiGarage have a friend who does this professionally and he is VERY expensive to the point you would rather buy or make another tank