An Honest Review - 2023 Bosch BITURBO Circular Saw // GKS 18V-68 GC
Ойын-сауық
#carpentry #powertools #woodworking
In this video I take the new @BoschProfessional BITURBO circular saw for a test. This 18V saw has a huge amount of available power and no issue with long deep cuts that some other 18V saws would shy away from.
Thanks for watching!
---------------------------------------------------------------------------------------------------------------------------
Links
Website - www.rangewoodworking.com.au
Facebook - / rangewoodworking
Instagram - / range.woodworking
My favourite tools and equipment
------------------------------------------------------
Pika Pencil - amzn.to/3UZ51dC
Jointer Safety Paddles - amzn.to/44WzRIs
Pony Jorgensen Parallel Bar Clamps - amzn.to/44WIWRv
Freud Glue Line Ripping Table Saw Blade - amzn.to/3KhaRlJ
Diablo Fine Finish Crosscut Table Saw Blade - amzn.to/450a3LO
Freud 8in SuperDado Stacked Dado Set -amzn.to/4bRzXDE
Stanley FatMax 8M Tape Measure - amzn.to/4bPAZjm
3M Worktunes Connect Bluetooth Hearing Protection - amzn.to/3QWwETB
RZ M2 Dust Mask - amzn.to/3R2g5Wp
Clamping Squares - amzn.to/3Kg1Rx9
Empire 16in Combination Square - amzn.to/3KhhtRe
Bahco 150mm Combination Square - amzn.to/3yuF9ia
Eclipse Dead Blow Soft Face Hammer - amzn.to/3QVzMij
Titebrush Glue Applicator - amzn.to/3KiGVpo
Stanley Chisel Set - amzn.to/3QYm6De
Пікірлер: 4
Good review, this has me confused. Question to all, why would you need track saw? if this circular saw can run on tracks and achieve similar results, specialy if only used for cutting down sheets. The only time you would need a dedicated track saw is if doing cuts close to a wall from what i can see. Does this do 45 degree cuts on track as well? Thanks for review
@RangeWoodworking
5 ай бұрын
Good point and good questions. Although this works with a track the track still has to start off the piece because the saw doesn't have the plunge ability. When you're trying to plunge with this one I find you tend to mess up the splinter guard which will reduce the cleanliness of cut over time. I didn't do any angled cutting I'm afraid, but I can't see why it couldn't.
Good video thanks. Do you know the measurement of the base plate please? W x L. Thanks.
@RangeWoodworking
7 ай бұрын
Thanks! The baseplate is 205x345mm