it is really good tutorial dear Vinay Goyal. I am doing a theses on composite cylindrical reinforced concrete shell water tank. however, due to the requirement of super computer I had to use segment of it for my entire analysis. how I shall represent the boundary condition of the model I am going to use? I will appreciate if you could do further tutorials on this. because this is becoming an area of research, so many people might follow you. thank you.

@VinayGoyal

3 жыл бұрын

I am not sure I follow the question can u ask the specific question

Thank you for you're video. I am doing the current analysis for my thesis but with one diffrence. You make you're geometry non symmetry because you only create one hole in You're model so you might perform riks analysis because it became nonlinear you can not use linear perturbation. Can you please add one more hole to youre model to make you're geometry symmetry and perform it again. The mode shapes are not symmetric which is my question. Thank you so much

Can u plz share the file??

@VinayGoyal

3 жыл бұрын

please make the model following the video