A New Door Seal

Автокөліктер мен көлік құралдары

It's time to replace the door seals.
The process is not all that complicated. After removing the old seal, you need to remove the old adhesive. The surface needs to be clean.
Then you apply door seal adhesive to both surfaces. It's a contact cement, so you need to wait a couple minutes for it to get tacky.
Finally, you can stick the seal to the door. Be careful because as soon as the pieces touch, there's no moving it.

Пікірлер: 14

  • @emmanuelcarrillo6330
    @emmanuelcarrillo63303 жыл бұрын

    Awesome I'm about to do this and a great video showing the process. It's nice showing I don't need to remove the door.

  • @mikerestoresanfj4069

    @mikerestoresanfj4069

    3 жыл бұрын

    Thanks 👍

  • @joesixpack7551
    @joesixpack75513 жыл бұрын

    HA! I told you that last project was not the last project for you! ...so did the trim adhesive loosen up that fresh paint? I know when I did my Bronco about 30 years ago, it reacted with the paint a bit and it was a two part Ditzler Deltron with hardener. Great video!

  • @mikerestoresanfj4069

    @mikerestoresanfj4069

    3 жыл бұрын

    There's no such thing as done. The paint was only a few hours old when I applied the adhesive and the paint did loosen up a bit. I checked the next day and adhesion was good. It didn't occur to me that this might be an issue. Most paints take quite a while to really get hard (days for sure). In retrospect, a heat lamp would have been a good idea.

  • @equals-kl9hm
    @equals-kl9hm2 жыл бұрын

    Where did you buy the new door seals from? I need to replace my seals too (1965 FJ40L). I have the old bug catcher windows any ideas on those seals?

  • @mikerestoresanfj4069

    @mikerestoresanfj4069

    2 жыл бұрын

    The front door seals came from Toyota Parts Deal which sells Toyota OEM parts. Toyota doesn't sell the rear seals anymore, so I used aftermarket seals from Cool Cruisers of Texas. You should be able to get the front vent window seals from these two sources.

  • @equals-kl9hm

    @equals-kl9hm

    2 жыл бұрын

    @@mikerestoresanfj4069 Thank you.

  • @segeryohanes130

    @segeryohanes130

    Жыл бұрын

    what addesive you use?

  • @carlosbarbon3855
    @carlosbarbon38552 жыл бұрын

    You didn’t say anything about how to remove or put on. You just did it and no one knows just how.

  • @mikerestoresanfj4069

    @mikerestoresanfj4069

    2 жыл бұрын

    Appreciate the feedback. I'll keep that in mind if/when I do any more videos

Келесі