A comprehensive user-friendly simulation model of ceramic capacitors
Relevant references
Zeltser and S. Ben-Yaakov, "On SPICE Simulation of Voltage-Dependent Capacitors," in IEEE Transactions on Power Electronics, vol. 33, no. 5, pp. 3703-3710, May 2018, doi: 10.1109/TPEL.2017.2766025.
S. Ben-Yaakov, "Some Observations on Loss and Hysteresis of Ferroelectric-Based Ceramic Capacitors," in IEEE Transactions on Power Electronics, vol. 33, no. 11, pp. 9127-9129, Nov. 2018, doi: 10.1109/TPEL.2018.2822771.
Пікірлер: 22
Prof. Yaakov is one of the few professors who is consistently working and publishing papers in pure power electronics. Hats off to you Sir. Many have drifted to other domains.
@sambenyaakov
Ай бұрын
Thanks for the kind note.
The #1 Professor of Power Electronics! Amazing as always!
@sambenyaakov
Ай бұрын
Wow😊. Thanks
Your video lecture is really helpful for me. Thank you. - from an power electronics engineer in south korea.
@sambenyaakov
Ай бұрын
Happy to hear that, Thanks for note.
Muchas Gracias Querido Sam Ben !!!! ❤❤❤👍👍👍👍
@sambenyaakov
Ай бұрын
Thanks
Hi sir could please make video on average model of peak current mode Active clamp forward converter
I suppose that at sufficiently low frequencies the limiting factor becomes the dielectric breakdown voltage. Can we speak of a typical frequency when that happens ? And if so, what is its value/range ?
@sambenyaakov
Ай бұрын
V and I are two independent limits , At low frequency V is the limit. At high I.
Thank you Professor...can you please make a video on how to simulate switched capacitor filter in LTSpice..
@sambenyaakov
Ай бұрын
Good subject. Will try. Look up for our papers on average modeling of switched caps converters.
@shamkumar730
Ай бұрын
Sure..thank you..
impressive! and beyond my level. why they don't make simple capacitors, simple behaviour? i never delved deep in this... years ago i tried a voltage multiplier, on maybe 1kHz, maybe 20kHz, i do not remember well, but it was not 100kHz, and it fumegated. tried with electrolitics, and the variations on the last capacitor were in 100V range. i understood there may be some problems, but i did not imagine how big. and at that time, it was no experience gained. as i said, not much thought into it. thanks for the presentation!
@sambenyaakov
Ай бұрын
Thanks for sharing. Things are less mysterious once you understand the fundamentals
@8:45, how is 1/I(B2) plot the impedance, not the ESR?
@sambenyaakov
29 күн бұрын
Since the excitation is 1V, 1/I is Z. At resonance it is equal to ESR.
👍🙏❤️
@sambenyaakov
Ай бұрын
Thanks
Make a VCO using these capacitors
@sambenyaakov
Ай бұрын
Good idea. WE have uses it to control resonant converters.