65 Impala Pro Touring LS Swap - Part 2
Автокөліктер мен көлік құралдары
With the 12 bolt rear end housing back from powder coating, it's time to fully rebuild the 12 bolt for the 65 Impala!
65 Impala Pro Touring LS Swap Playlist - • 65 Impala Pro Touring ...
Other videos we recommend watching:
Super Clean 57 Chevy found in the middle of NOWHERE - • Super Clean 57 Chevy F...
Old & Busted Gets a Big 12 Bolt Rear End Upgrade - • Old & Busted Gets a BI...
Here at ZHP garage, we do it all. Tune in every week for a look into our custom builds, arrays of car shows we attend, general service/how to videos we make, and multitude of races we participate in. We have over 25 years of experience, and can work on anything from the daily commuter, to a custom fabricated roll cage, to a custom Chevy C10!
For behind the scenes action, more look into our builds, and things not shown in the fully released videos:
Follow us on Instagram:
Camera Man: / rhziggy
Master Mechanic: / zhp72
ZHP Garage: / zhp_garage
Give us a like and check us out on Facebook:
ZHP Garage Facebook page: / zhpgarage
#zhpgarage #12boltrearend #65impala #protouring #lsswap
Пікірлер: 10
I very much appreciate the quality and camera work involved.. 👌
I always buy spare bearing for pinion bearing and wallow out center one so that it slides over pinion and test pinion depth after getting shim side then put in other bearing found if you heat bearing up it will side on easily ! I use an old oven to heat bearings on carrier and ring gear to set them in place!? But Everybody needs to do what works for them! I think You forgot to wipe off pattern paint! Also 12 bolt truck and 12 bolt car are different !
Nice tips a tricks! Can I come sweep your floors just to watch you work !?
That’s a 10
Very detailed man ! 🔥
Damn good video this is going to be a GREAT series
bro your meme selection for these videos is undefeated lmao
We need the apart list for the rear end build 😊
Great video! Can you provide the part number for the wilwood brake kit?
I wonder if could put the ring gear ⚙️ into the freezer over night 🌙 I've seen people do that on bearing and they slide right on. Remember work fast when doing that.