doing good job keep it up

Thank you so much.

New subscriber bro🔥🔥🔥

Great video 💯! What is the part number for those flywheel bolts ?

When putting engine in did you have to do anything for oil pan clearance

Have you ran the set up yet with that pilot bearing and if so have you had any issues Or further recommendations

And don’t forget to use brake clean on the flywheel before installing the clutch disc. Finger prints and grease on the flywheel will make your clutch chatter.😂

Does the stock sm465 bell housing bolt to the ls

Were you able to bolt it to the ls while using the factory input shaft and small block chevy bellhousing on the muncie?

@JCustomFab

9 ай бұрын

Yes, a bolt's right up. The only thing you need to do is get the right bushin or bearing for the input Shaft ride on. But you definitely have to get the right fly. Wheel and a stock clutch and pressure plate will bolt to it

Did you use a swap oil pan or did you make the aftermarket pan work?

@JCustomFab

7 ай бұрын

I did use the stock truck ls oil pan As long as you got a two inch or bigger lift

What year LQ4, and can you explain how the ALL26112 spun on the shaft, I’m confused, I know the the 6.0 LS had two different size shaft the pilot rides on based on the generation, I’m currently doing this swap with a 2002 LQ4 into a 1978 with the sm465

@JCustomFab

4 ай бұрын

I'm not sure how it spun. But it did and when I installed it, it was Very tight. There is 2 different depths to the crankshaft on them. Depends on your output shaft.

What are you using for throw out bearing/slave cylinder?

@JCustomFab

8 ай бұрын

kzread.info/dash/bejne/ioh1t7KBmpDXidI.htmlsi=PJtGJuoUO4sANG1x check this video out.