Nice work as always sir, I picked up one of those board heaters as well for Series X boards, may have to try it for the next PS4 Slim south bridge too!

Nice work, excellent explanantion and calm repair....well done!

Another great repair fella!! thanks for sharing.

Good repair and clear information again keep up the good work

Nice job bro, always with the good info <3

Amazing work man 👍🏾

Thanks a lot for your very interesting videos.

Really enjoy all your repair video, you really have the patient and knowledge. May i ask if the PS4 Slim RT5080 PMIC also have the same data output as the TC7739?

Great vid,thank you.

Excelent job brother

great work! I'm struggling with similar issues with 2 PS4 slim in these days. I'll give a try also to clock replace ;-)

Hi! I'm having the exact same simptoms, measuring 0.335V on the left side where it should be 0.275 and the same on the bottom side of TC7739. These are not going to the SB so I'm not sure if that it the correct part to replace. If you look at the board with the hdmi port on top, you see two cap-coil-mosfet pack at the top left corner of the APU. On the bottom pack I measure only 30ohms, and it goes directly under the APU. (I measure 30ohms and 0.05V on almost every component directly under the APU) Could this be a dead APU and not a SB? Thank you!

nice video man, really appreciate the knowledge, I have a ps4 slim that have a similar issue, I checked the mosfets and they had a short, I changed them but there was still a short at the coil right next to it, what do you think might be causing it because I tried and with no luck unfortunately

very nice one 🤩🤩

أحسنت أخي العزيز

hey have you ever seen the RT5080 on these board? I believe it is the standby IC. If so, do you happen to have the datasheet? I think I have a board that this chip is shorted on pins 2 & 3. Also, do you know where I could get them? I am also wondering if there are compatible chips from other manufactures

How ever if u remove the battery the ps4 do turn on when u apply power . So cmos battery is not needed for boot up.

I TAKE OFF MY HAT FOR THIS GREAT JOB, I HAVE A SIMILAR CASE THAT FIRST I HAD A FLASHING BLUE LIGHT AND AFTER DISASSEMBLY AND JUST CLEANING THE PLATE IT DID NOT TURN ON ANYMORE IT JUST BEEPED THE EJECT BUTTON, I CLEANED AGAIN AND THERE IF IT WAS DEAD I DID NOT DO ANYTHING . I NOTED THAT THE VOLTAGE REGULATOR HAD A DOUBTABLE LINE ACCORDING TO THE REFERENCE MEASUREMENTS THAT MATCHED THE ONE IN THE VIDEO, FOLLOWING THE SAME LINES, I INSULATED THE COMPONENTS AND THEY CONTINUED THE SAME AND I DECIDED TO CHANGE THE REGULATOR AND THE RESULT WAS THE SAME.

معلومه ممتازه

i have the same model and recently my building got hit by lightning 😶 fried everything plugged into the north wall, including my ps4. im gonna open it up in the next few days to see what exactly happened, im hoping its just the power supply. there’s no beeping for the power button or eject button…