#Abaqus #Bending #Simulation In this tutorial i will show you how to simulate analysis of elastic plastic three points bending beam test .
Жүктеу.....
Пікірлер: 18
@12345johi3 жыл бұрын
Hello, great work, thank you very much for this tutorial! I have please a question regarding the elastoplastic material parameters, where did you obtain them? Literature? Best and thank you!
@Abaqus_basic4 жыл бұрын
Very interested
@TheBouchra102 жыл бұрын
thank you for this helpful tutorial, I have a question about the friction coeff it represents the material or the support parts? can u explain please
@qmtv57724 жыл бұрын
Hello, it's very interesting. I want to do simulation for bending test on ceramic materials by Marc Mentat. Do you have a user guide for the bending test?
@cssa28932 жыл бұрын
Error "Time increment required is less than the minimum specified" occurrede
@hrishikeshdeodhar46983 жыл бұрын
I'm getting there is no valid step data after clicking results...pls clear my problem
@moussaouianouar13793 жыл бұрын
I get an error، Too many attempts made for this increment. How do I fix it
@shayanrjb5985
Жыл бұрын
Same
@mumbojumboddot Жыл бұрын
hi, i am having an ERROR stated below after following the video, THE SECONDARY SURFACE ASSEMBLY_S_SURF-23 DOES NOT EXIST. SECONDARY SURFACE ASSEMBLY_S_SURF-25 HAS NOT BEEN DEFINED what should i change, edit.
Пікірлер: 18
Hello, great work, thank you very much for this tutorial! I have please a question regarding the elastoplastic material parameters, where did you obtain them? Literature? Best and thank you!
Very interested
thank you for this helpful tutorial, I have a question about the friction coeff it represents the material or the support parts? can u explain please
Hello, it's very interesting. I want to do simulation for bending test on ceramic materials by Marc Mentat. Do you have a user guide for the bending test?
Error "Time increment required is less than the minimum specified" occurrede
I'm getting there is no valid step data after clicking results...pls clear my problem
I get an error، Too many attempts made for this increment. How do I fix it
@shayanrjb5985
Жыл бұрын
Same
hi, i am having an ERROR stated below after following the video, THE SECONDARY SURFACE ASSEMBLY_S_SURF-23 DOES NOT EXIST. SECONDARY SURFACE ASSEMBLY_S_SURF-25 HAS NOT BEEN DEFINED what should i change, edit.
@ABAQUS_SIMULATION
Жыл бұрын
Hi Contact me at aekabaqus@ gmail.com
dimesnions are in mm or meters
@ABAQUS_SIMULATION
4 жыл бұрын
mm and MPA
how much times it takes to complete simulation
@ABAQUS_SIMULATION
4 жыл бұрын
the system unit is mm and MPa
dimensions are in mm or meters
@ABAQUS_SIMULATION
4 жыл бұрын
mm and Mpa
please reply urgent
@ABAQUS_SIMULATION
4 жыл бұрын
mm and MPA