This is perfect.....Ordered exactly the parts you identified.....assembled using three wire install...and it worked perfectly for parking mode on my new Blackvue 4K dash cam. Saves me from running another long wire, and dinking around the fuse box in my brand new 2021 Sienna. NOTE1: Make sure you push those pins as far into connector as they will smoothly go. You should see the edge of the insulation from onto with connector clip removed (see NOTE 2) NOTE2: There is a clip on the toyota connector that needs to be removed carefully and reinstalled evenly once the pins are laid in there. I ultimately figured it out vs trying to install the pin by pushing into connector from back, just make sure the retaining clip slides straight down and is properly retained so it will properly retain the pins.....and I wish I had a 2.54mm crimp tool (not part of my normal automotive tool kit, and not cheap to find a good one)...but a small needle nose allowed me to do an acceptable crimp on the pin - take your time. I found that NOT DISCONNECTING pin from the rack it comes in helped hold it steady while I crimped it this way..Crimp the insulation wings first...then remove the pin once you have the insulation crimp done...then finish the other conductor crimp. I suggest you practice on a spare pin/wire before doing actual crimp this way. Remember to do a pull test on the installed wire to make sure you got the pins captured correctly - give it a good tug so you know you have the pin oriented correctly and the retaining tang is gripped properly. You dont want it to dislodge when you assemble the connectors or rattle loose over time. Thank you so much for your work to post this.

@LonZeman

2 жыл бұрын

My Rear view mirror camera has only one black and one red wire - there is no third or white wire - so just use the black and pink slot ??

you're the man. just wired a dash cam for 24/7 recording on my 2022 Sienna XSE. :)

@amirovz

2 жыл бұрын

Does the dashcam drain the car battery when wired to be on at all times?

Michael thanks for all the useful information about the 2021 Toyota sienna factory plug connection!

oh god haha radar detector reminds me of my dad when he was going 90 in a 50 when I was a child holding on for dear life. That thing chirped constantly 😂

Thanks for making this video! I can see using this 12v source for other applications. Nice clean install

Thank you ! ordered the parts in your description and was able to install my dashcam , I used the 3 wires for parking mode.

@smartmeatball

2 жыл бұрын

When you turn off the vehicle, does your dashcam still get power supply?

@hassanbou2236

2 жыл бұрын

@@smartmeatball yes, dashcam will keep recording on parking mode .

@smartmeatball

2 жыл бұрын

@@hassanbou2236 I thought it will power off as this video said.

@reythegrey143

2 жыл бұрын

@@smartmeatball use the black wire on the car for your ACC (most likely the red wire on your dash cam) this will keep the dash cam on even when you turn it off, the pink cable is the one that turns off the dash cam when you turn off the car, the white wire with black stripe is where the black cable on your camera connects to. Hope that answers your question. Btw, I just used T taps on the wires where you can buy from auto shops instead of buying the housing connectors which is less than $4 but the shipping cost more than the actual item.

@smartmeatball

2 жыл бұрын

@@reythegrey143 thank you so much, would you be able to post the link of t tap? 🙏

thanks for sharing the video. I was going to run the 12v from fuse box. now I can make it much shorter.

Thanks, I instead bought a Subaru H501SSG010 which is already wired to another connector. Just cut that in half and didn't have to deal with the pins

Nice, radar to drive like maniac, to not respet speed limit, and put in risk others drivers including you'r fam..

nice video. placed my order for the connector and I will install my dash cam this way

Thank you for doing this video!

Very helpful video!! Now I able to upgrade my interior lights to LED…

@smartmeatball

2 жыл бұрын

For led lights, I believe you just need to replace those original bulbs to led bulbs. I watched a video of that before.

Thank you 🙏

i just bought 1 for my sienna 2021 i bought it at Toyota can you show me how to wire it up and get it working thanks

how did you get that part number? I need the part number for the blue connector

How did you open ceiling control panel. İ cant 😞

@SciFiFan20

2 жыл бұрын

it was really snug- but i was able to pull it down with my bare hands. just go slow and try pulling from the part closest to the front of the van.

@mikekose

2 жыл бұрын

@@SciFiFan20 I did it thankfully

I cannot for the life of me remove that overhead console ughhh