Hi there my man it is more easier if you instal the clam side first

I just did this, took two grown men to get that hose seated in the breather box. I opted for a traditional hose clamp screw type instead of that spring clamp.

@SlightlyLessFat

3 жыл бұрын

Yeah. 5 minute job turned into a KZread video! Haha!

@Zrathor

2 жыл бұрын

I just used a touch of my synthetic oil to lube the hose very slightly and it seated very easily. Dry rubber on plastic is hard to force into place.

FYI the velocity stack O -Rings are supposed to be at the bottom above the screws so if the screws come loose they don’t bounce around and go down into the engine..

@SlightlyLessFat

3 жыл бұрын

Oh! That makes total sense! Thanks for that answer.

Great video. Thanks for sharing. Why this happens? I am having the same issue but I use Loctite Super glue in the cracks. Planning to install different hoses that will run to an oil catch can.

@michaelwhorley1573

10 ай бұрын

If u do a catch can would u make a vid? This house craps out every year! Cheap rubber!

Good Job, Slightly!

That helps me. Thank you.

@SlightlyLessFat

3 жыл бұрын

For sure. I thought I had serious problems! Glad it was just the breather!

Thanks for making this helpful video 👍 glad I found your channel just subscribed

@SlightlyLessFat

3 жыл бұрын

Absolutely! Hope my content is amusing! haha! Thanks for the subscription!

My 12 v rod idles and runs crazy. I had a p0113 code for a AIT sensor. I put a new sensor and still does same thing but the code p0113 does not come up anymore. I already replaced fuel pump not fuel filter though

Dude thank you so much

@SlightlyLessFat

3 жыл бұрын

For sure! I have a couple more videos with the bike I want to do. Hope you enjoy those when I post them.

Is this oil leak problem same in 015/016/017 vrod muscle?

@SlightlyLessFat

2 жыл бұрын

Yeah. Even models back to 09.

@balwa999

2 жыл бұрын

@@SlightlyLessFat is this oil leak also a problem in night rod special 013+