2013 Mazda 3 SkyActive 2.0 L Starter Replacement
Starter removal / change for 2013 Mazda 3. I think the procedure should be the same for model years 2010, 2011, 2012, 2013, 2014, 2015 and 2016 with SKYACTIVE 2.0 L engines.
Tools used: 10, 12, 13, 14 mm shallow and deep sockets. 3/8 regular length and a stubby ratchet. 3" extension. Small flat head screw driver.
.
⚠️ DISCLAIMER: Use of the information in this video is solely at your own risk. The creator of this video assumes no liability for any property damage, injury or expenses incurred as a result of any of the information contained in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. The creator of this video makes no claims, promises or guarantees about the accuracy, completeness, or applicability of the procedures and instructions contained in this video. Any injury, damage, or loss that might occur as a result of improper application, improper use of tools or equipment, or from the information contained in this video, is solely the responsibility of the user.
.
Пікірлер: 9
it's always a pain in the ass to find videos on 2012-2013 mazda3 skyactiv version videos. thanks for this.
@sulla9528
3 ай бұрын
I'm glad if it helped you. Thanks
Hello, I have the exact same car. When I turn the key I have all lights on, but nothing happens. I will try this. Very informative and detailed video. Thank you so much for posting it.
@sulla9528
3 ай бұрын
Thanks
Mine starts with a push button. Is it the same?
@sulla9528
3 ай бұрын
If yours is the same year and has the same engine then it should be the same
Are you turning both bolts in the same direction?
@sulla9528
25 күн бұрын
Yes. if you are removing them then you rotate them anti-clockwise and when tightening them then you rotate clockwise.
@dreamvillez
25 күн бұрын
@@sulla9528 okay one more question, I saw you tighten/loosen the bolt attached to the starters, the bolt that goes under the plastic cover. If that's attached to the starter, does that need to be tightened or loosened? I'm asking because I don't wanna miss any steps