best video out there for 8th gen civic si clutch replacement. great job

Very good explaining everything step by step 👌🏻

@alltsab

4 жыл бұрын

Thanks

This video Is all the what i need for change my transmisión my self thank so much my Man youre the máster ✌️

@alltsab

4 жыл бұрын

Please help subscribe thanks

@julianelias6747

4 жыл бұрын

@@alltsab yes im doit right now tanks

Great job.

Love the video

Good job bro.

Wow. Subscribed. You make this look so easy. Just did this with the motor and tranny out and it was still hard. Zoo heev brother! Subscribed.

@alltsab

10 ай бұрын

Ua tsaug nawb.

THANK YOU. REAL GOOD INFO AND VIDEO

@alltsab

2 жыл бұрын

Thanks

What should I look for when replacing flywheel and how many times have you not had to replace one?

No issues using the support bar on the fender to hold the engine up?

Good job, so detailed, thanks, i have difficiulty putting back the trans, as i don't have the trans jack

@alltsab

Жыл бұрын

You welcome buddy

Awesome.

Hey brother, how much you charge to replace the clutch, clutch master and slave cylinder

W vid

Well Done Sir, how much does the labor cost?

Hey man are you in California and do this as your job? Would love to have you as my mechanic as you look like you know your way around these cars!

Excellent video! What size was the bolt you used to attach the engine support bar chains to the engine block?

@alltsab

4 жыл бұрын

Sorry I'm lost here. Did you mean the bolt I used to hold the subframe?

@Hennrock837

4 жыл бұрын

All Tsab No problem. I meant the bolt you used at 10:40 in the video to attach the chains.

good video. what kind of ratchet wrench were you using most of the video? it looked like a thin flex head wrench but with a socket on it.

@alltsab

3 жыл бұрын

Buy it cheap from harbor freight

@alltsab

3 жыл бұрын

Cheap but work best

How much for clutch replacement for honda accord 96

Where did you attach the chain to support the engine??? Got pictures???

@alltsab

4 жыл бұрын

used strap tie wrap around the tranny be careful with sensor

*_Great video! And I love the Fiji Blue Pearl Mugen!_* (๑╹◡╹)ﾉ"

Are you located in CA and have your own shop? I would like to get my clutch replaced soon. I would do it myself but I don’t have the time or the tools.

@alltsab

3 жыл бұрын

No shop I only do it for my family only

hey bro, same process for the Coupe 2008?

@alltsab

3 жыл бұрын

Yup

Good job but for me it looks complicated.

@kristopherjulian3613

2 жыл бұрын

instablaster

How much oil you use for this transmisión? And whats can a oil ? Thanks máster ✌️

@alltsab

4 жыл бұрын

Not too sure how many quarts but pump until over Flo that all you need. Go to honda buy the manual transmission fluid ask them for s2000 tranny fluid they will sell you the exact type and amount. Ok

@julianelias6747

4 жыл бұрын

@@alltsab apeciate boos thanks for yoy suporte✌️

IDK if I can do this after watching your video. I don't have all the tools especially how I am going to hold the engine up. I might just bite the dust and pay a shop to do it. :/

@alltsab

3 жыл бұрын

It's doesn't need a lot tool or special tool to do it. As long you know how to follow instructions and have a lot patient about it.

@madam497

3 жыл бұрын

Advice on dropping down the transmission without a transmission jack? I am at the 15 minute mark of your video. Thanks

Which clutch kit?

@alltsab

3 жыл бұрын

Exedy clutch kit

How do you install transmission back to engine?

@alltsab

3 жыл бұрын

Did you watch the video?

@_cyang

3 жыл бұрын

All Tsab yes i followed all your step doing my own clutch but i just cant align the transmission to the engine

@alltsab

3 жыл бұрын

@@_cyang remember in the video used long bolt to help alignment the transmission pin holder. Used long bolts to hold the transmission so you just slide it in.

@_cyang

3 жыл бұрын

All Tsab how do you get the two holes so close to each other to connect?

@alltsab

3 жыл бұрын

@@_cyang if you align with long bolts slow yank it and push it will go in. Did you used alignment tool to align you clutch?

How much does a job like this cost?

@alltsab

2 жыл бұрын

Different shops place Different prices. Myself just a case of beer

@MINAR3L_GR3Y_2V

2 жыл бұрын

@@alltsab my civic si is in need of a new clutch at the moment lol

when you have all the tools it's easy😅 maybee