2006-2012 Toyota RAV4 Rear Wheel Bearing Hub Assembly (How to) Replacement
Автокөліктер мен көлік құралдары
This Toyota RAV4 is getting new rear wheel bearing hub assemblies!
😎If this video has been helpful consider supporting us with a cup of coffee! 🙂
www.buymeacoffee.com/ValleyMo...
🛒PARTS LIST:
▪️ Wheel bearing AWD OEM: amzn.to/3T0AOv4
▪️ Wheel bearing AWD aftermarket: amzn.to/3ONryYA
▪️ Wheel bearing FWD OEM: amzn.to/3IoIpxz
▪️ Anti- sieze: amzn.to/42wZ2QS
🛒TOOLS NEEDED:
▪️ Electric ratchet: amzn.to/3Sw4W12
▪️ Impact socket set: amzn.to/3Hy3fKi
▪️ Impact wrench: amzn.to/3Sfmiht
▪️ Prybar set: amzn.to/3IkSlWw
▪️ Breaker bar: amzn.to/42eP7Pq
▪️ Socket and wrench set: amzn.to/4b6K8ob
▪️ Torque wrench 1/2: amzn.to/3AgaOB2
➡️I am part of the Amazon affiliate program and get a small commission when purchases are made through the links provided.
🔺DISCLAIMER
The information provided by Valley Mobile Automotive (“we,” “us” or “our”) on this video is for general informational purposes and entertainment only and does not replace professional advice.
All information is provided in good faith; however, we make no representation or warranty of any kind, express or implied, regarding the accuracy, adequacy, validity, reliability, availability or completeness of any information on the video.
By working on your own vehicle, you take responsibility for the outcome.
Under no circumstance shall we have any liability to you for any loss or damage of any kind incurred as a result of the use or reliance on any information provided on this channel. Your reliance on any information on the videos on this channel is solely at your own risk.
Пікірлер: 12
Great video 👍thanks for posting it.
great job and thanks for sharing safe me alot of money going to a shop
Excellent video. Just what I needed. This is so simple for an AWD car bearing.
@MavHunter20XX
27 күн бұрын
unless its rusted in there good. Might need a slide hammer puller or a lot of percussive action.
Good vid, Toyota makes that almost painless!
❤watching from France...Very clear explanation and video..THANKS SIR...
@ValleyMobileAutomotive
6 ай бұрын
Welcome! Glad you found this video 🙂
Thanks…My 2008 drivers side dust plate on rear is rusting thru.Unfortunately have to pull bearing to replace.Tried to find a Dorman one that is a split unit so it can get slipped on after removing bearing bolts.Ever do one ?Also did you inspect the rear k frame support on that probably right where you jack stand was is where they rust out.Replacing mine as we speak,Not cheap.Common problem on these.
good video - thank you. how long is this job to complete?
@ValleyMobileAutomotive
5 ай бұрын
I feel this can easily be done in less than two hours.
My axle doesn't push in at all! Tried beating with a 5 pound hammer and everything. The bearing is stuck to the axle. Help!
@ValleyMobileAutomotive
2 ай бұрын
Ah man! I've had that happen on vehicles before. You might need to use heat like an oxygen acetylene torch on the axle. Then replace the axle and bearing at the same time.