Think i need to do this to my 96, looks like a hell of a job lol

@MotoMedic

5 жыл бұрын

Not all that difficult... Just takes patience and time.

@teds4983

5 жыл бұрын

@@MotoMedic right on, thank you for the video. Ya my bike is right about the same miles. Not bad for a 23 yr old bike

@MotoMedic

5 жыл бұрын

@@teds4983 keep up on maintenance and it'll last you a looooong time

@teds4983

5 жыл бұрын

@@MotoMedic that's Honda for ya

how do you get slack in the cam chain tensioner? and is that needed in order to do the valve adjustment. I ask bc I just bought a cbr 929 2001 and am going to attempt a valve adjustment for the first time ever. Thanks for the vid!

@MotoMedic

5 жыл бұрын

Take the bolt off of the tensioner (10mm) and with a small screwdriver turn clockwise. The tensioner will close. If you're just inspecting the clearances, no. If you have to pull the camshafts for any reason then yes, it comes out to allow slack to the cam chain.

Did you happen to run the bike before doing the valves? If so what did it do and how did it act?

@MotoMedic

3 жыл бұрын

The bike was running OK but the cam chain tensioner was fused and not putting any tension on the chain. Lots of chain lash was the sound. Normally you won't necessarily hear anything unless it's so bad that a piston is coming in contact with a valve. It'll sound like a small knock and if you hear that... shut the bike off immediately and check them for spec. Rule of thumb is: Valve inspections/adjustments are just as important as regular oil changes. Don't ever let it go just because it all sounds good.

@Rodeshion

3 жыл бұрын

@@MotoMedic well I have one I've been building for a drag bike and it starts up perfectly fine but when I go to give it throttle it surges really bad then shuts off. Brand new carbs brand new ignition brand new everything and it does it still.

@Rodeshion

3 жыл бұрын

@@MotoMedic it surges about 4 times before shutting down ,so someone told me to check my valve clearances and I did yesterday and they were all tight as hell my thinnest feeler Guage won't even go in and it's. 002 is that more than likely my problem or could it be something else as well?

@MotoMedic

3 жыл бұрын

@@Rodeshion Tight is bad! Definitely time to pull the cams and re-shim.

I don’t rag on my bike (2019 Honda 1000RR) I do run it but , I’m not racing. Mostly mountain roads. Does it help when I have to check shims (16,000) being easy on it?

@MotoMedic

3 жыл бұрын

Always check them on the recommended mileage based on the manual. Adjust when needed. That's the best way besides regular oil changes to keep it running as long as possible.

@dbtrackz33

2 жыл бұрын

Do it you lazy fuck. Fucking people looking for excuses not to do their part....