1985 Jeep CJ7: Valve Cover Upgrade
Ойын-сауық
In this video, the objective was to stop the leaking oil down the sides of the engine block. Here, I upgrade to a cast aluminum valve cover, getting rid of the OEM plastic piece of junk, and a FelPro valve cover gasket.
Пікірлер: 7
Nice , fairly straightforward project. Good looking valve cover too!
@Curts_C10
Жыл бұрын
Thanks! Hopefully, I won't have any leaky issues coming from it anymore.
Just did the same project about 2 months ago. Instead of bolts I used studs with T bar hold downs; it makes the one in the rear much easier to deal with.
@Curts_C10
Жыл бұрын
That's a good idea! However, I don't think id have enough room in the back for a T-handle.
@andrewgraham9977
Жыл бұрын
@@Curts_C10 You don't, the bar hits when you turn it so I knocked it out and just use the end of it(or a small phillips screwdriver) in the hole.
Nice job! Man I was hoping to see a good shot of how you mounted your air conditioning compressor! Only thing I can find is for serpentine belts!
@Curts_C10
Жыл бұрын
Thanks Jim. The bracket I used to mount the compressor and alternator was that which came with the kit, which I bought from Jeep Air. It was a bit of a pain to install, but a nice bracket specifically made for this application.