Пікірлер

• 
  @s2pointohАй бұрын

  This linked from the 5 pt harness-how do you install the 5th point? Can you use a 5 pt aftermarket harness on OEM seats?

• 
  @BlackOpsMachineАй бұрын

  On this install, we used to oem X3 seats, so yes you can absolutely use a factory seat, but this will vary depending on the make and model. Ultimately, you'll be able to run these seats on any vehicle with enough effort. All things considered, using the 5th point (the in-between leg strap) is optional based on what you want. The owner of this X3 that we did the video on didn't want it, so we decided not to use it. If you wanted to use the fifth strap, you would just need to mount it somewhere in the middle of the seat on the floor or connected to that cross bar that the front of the seat is bolted to.

• 
  @s2pointohАй бұрын

  @@BlackOpsMachine got it - thank you!

• 
  @lifeofthesavilas122 ай бұрын

  I was looking at your yxz spacers when you order does it come in pairs or everything is separately

• 
  @ryanb67652 ай бұрын

  All spacers are sold in pairs. They are currently on sale on the website as well!

• 
  @dustinhernandez67002 ай бұрын

  Would this work with the Hess steering flag?

• 
  @ryanb67652 ай бұрын

  We haven't tested it with their steering flag. I assume it is the same fitment though.

• 
  @timatkinson44364 ай бұрын

  What size socket do I use to trq nut?

• 
  @coreyhannigan39795 ай бұрын

  Great video it’s going to help me out tomorrow a lot

• 
  @BlackOpsMachine5 ай бұрын

  Love to hear it man! Bit of a lengthy process but you got it!

• 
  @christophergarza3482Ай бұрын

  This is a lot of work. How much is it to install it?

• 
  @jfmjr19705 ай бұрын

  Way to go you ROBBED the HESS design and have it made in China!

• 
  @BlackOpsMachine5 ай бұрын

  There is only so much room in the area to make a supporting brace for the steering rack without doing something like Sandcrafts design. We made a brace with an unpatented design to bring an affordable option to the market. Thanks for your comment.

• 
  @kenwaddle587 ай бұрын

  Why don’t you show how to remove the balljoint out of the knuckle?

• 
  @BlackOpsMachine6 ай бұрын

  We must've just clipped it out as it wasn't too climatic. Once you remove the ball joint bolt, it should easily pull up out of the knuckle. If it doesn't, try lightly encouraging it with a dead-blow. It shouldn't be too seized in there.

• 
  @JsGarage8 ай бұрын

  That's a worn letter U on that OEMTools Ball Joint adapter. Just to help folks out.

• 
  @timjenkins60499 ай бұрын

  Great video, thank you.

• 
  @BlackOpsMachine8 ай бұрын

  Thank you for watching! We appreciate the feedback.

• 
  @vaxg98269 ай бұрын

  💋 'PromoSM'

• 
  @justonh93569 ай бұрын

  Size of the top nut?

• 
  @ryanb67659 ай бұрын

  45mm