I'm a mechanical and automotive engineer who is so passionate about vehicles especially automobiles.
My Apologies if I am not able to answer all of your questions and/or reply to your comments as I have a pretty busy schedule but I promise that I will try my best.
Disclaimer: The material and information contained on this KZread channel is for general information purposes only. You should NOT use as a substitute for the advice of an appropriately qualified and certified auto mechanic. You should NOT rely upon the material or information on this KZread Channel as a basis for making any business, legal or any other decisions.
Пікірлер
What’s the best way to add more Hp to this car?
If it's stuck in park. You can use a small deadblow and tap on the top of the shifter and giggles it out of park
It is also available in middle east market
Thank you, bro. I wanted to see how it you purple.Get the air of the lines
Truck i just got will go into gear and pull for a minute..then stop pulling..if i turn it off and wait a couple minutes and restart..it will fall into gear and pull again..when i connect scan tool it says no communication..help
Need help..you seem to be the man to ask.
Hi can I call you to ask you a ?
Why did i love this video so much???!!!😂
do i have to replace clutch after stage 1-2 ktuner or hondata? any one have some experience with this? MT version neds cluth upgrade
I was told by a trusted source. These transmission were made by BMW and was bought by GMC.
Can you override when de car is stuck in parking?
Is it possible to show a bit more in detail about the hose modification you did toward the back of the engine just before removing the intake manifold? I began the process and the passenger side if rather easy but the driver side is pretty involved especially since it has the computer, computer mounting bracket, and transmission dipstick to contend with. This video I very appreciated. Please continue to make more with this engine. I have a 2014 GLK 350 4-Matic and need to perform this job.
Could the speed sensor cause an intermittent hard shift only when shifting from 4th to 5th gear? I can't figure out why, sometimes its smooth as butter and sometimes the car will cause a "thump" when shifting. Usually when accellating under higher load, it will linger the rpm when i left off the gas,....and then a delayed shift to 5th.
any updates? turbo still working?
Used car lot mechanic knows more than factory mechanic 🥳
Is there a procedure to bleed air out of the fuel system before startup?
R.I.P Ozone layer
I always thought this engine was turbocharged. Checked everywhere before I finally found this video to confirm. Thank you.
Check the fuel injectors and the seals
U didn't show anything
Where did you buy the socket?
Thanks your video gave me the information I needed without hearing someone’s life story it answered all of my questions to repair my car thanks you. Ed Tennessee
Bmw, or specifically rolls royce, claim the metal T fittings get a lot hotter than the plastic counter part and cause hose swelling and splitting earlier than if used with a plastic piece. While the T won't break, the hoses will and at an accelerated rate.
This is Not a review, you just took a look under the hood.
Hi. You might have an answer. I have P0741 for torque clutch solenoid. When putting in reverse it sometimes stalls. I replaced the fluid. But code still there. I also notice lower MPGs. Thanks.
this is the most useless video ever
Hi. my car pathfinder 2010 4.0 when changing gear from P to D or from R to D, there is always a delay of 2-3 seconds when shifting to D. The rest works very well. What can be? Electrovalve? I have new, original oil. Could some solenoid valve be responsible for this? while driving everything is ok. this is most noticeable when it's hot. and when I change from R to Drive. thank you for the information
Just a little tip, you don’t need to start the car to bleed the system. You simply turn heat all way up and blower on lowest fan speed then press gas petal for 12 seconds to the floor . You will hear the electrical pump start purging it cycles off and on for 10min roughly
How do you put the shifter into neutral ? With no power
Turn key to position 2, press brake pedal, shift to neutral
Better then taking the glove box apart 😅
Could you maybe put in a link for the speed sensors? I can't find them online.
Great info. Thank you. But does rhe products from china reliable?
Mine just broke. Is there a connector on drivers side too? Is there a bleeder on either side connector? 3/4" connector? Thx
Wrong oil
Would this be similar to the system found in a 2015 b250 4-matic? And would you say the chain has to be replaced on all 4matics after 100 O00 miles?
Yuo mean Ford V8. Land Rover got them supplied by Jag but Jag had them supplied by Ford. When you take the heads off one there is still a Ford sticker and part number on the back
Great video, thanks so much!
you happen to know any DISA valves on this engine? Thanks
thank you
A headlight replacement video should start with the light in the fucking car not start a how roo video with it already pulled sitting on. BENCH
I didn't have a fuel pump job but watched your video anyway. It's simply because the effort you've put together a clear and concise tutorial for the future reference. Thank you very much!
I need your assistance
5 million can buy four G63 2024 model and ten rolls Royce Wraith but na for picture you go dey watch am 😂😂😂
Great video. Honda does not publish a service manual these days, where can I get a service manual with torque specs, wear limits, etc. For a honda BB7A 6 speed from a 2015 Accord?
What does a repair like this cost?
I’m getting misfire under load all on bank 2 misfire codes for cylinders 5,6,7 and 8 I think an injector might be leaking or fuel pressure is bleeding off for whatever reason, if you leave the car for 5 minutes it’s a hard start (extended crank 10-15 seconds) but if you turn it off and back on quickly it starts right up. I’m gonna test fuel pressure than swap injectors from one side to the other and see if the problem goes to the other bank. If not maybe throw a fuel filter and pump at it? Idk
No
Thank you.
I didnt hear no engine sound
Good