Пікірлер

  • @orion5813
    @orion58137 ай бұрын

    did you record this with a nokia 5110?

  • @NoOne56488
    @NoOne564888 ай бұрын

    I have the Manta on my XR8 Sprint, sounds lot better in person than the video. The only issue with the Manta is the fitment over the rear axle, it's very tight unless they have changed it since 2017 when i got mine done.

  • @tommorais7776
    @tommorais777611 ай бұрын

    Anyone still has their car ticking after few years? Bought a MY2023 and it ticks since new

  • @fukkinjesus
    @fukkinjesus Жыл бұрын

    filmed on a potato encased in a potato wrapped in a potato, using a potato to edit, and displayed in potato vision. I think my commodore 64 had better video quality and sound

  • @niceflicks
    @niceflicks Жыл бұрын

    Intention is lost on some - all the best playing River Raid.

  • @martinellul1604
    @martinellul1604 Жыл бұрын

    @@niceflicks Wow forgot all about River raid 😆

  • @BradBrown95
    @BradBrown95 Жыл бұрын

    I’m rolling 🪤🤣🤣🤣🤣

  • @leomeares2270
    @leomeares227010 ай бұрын

    lmao

  • @user-Clint315
    @user-Clint315 Жыл бұрын

    Sounds much better than the xforce I have on mine. Nice mate

  • @petermanuel7128
    @petermanuel7128 Жыл бұрын

    I’m thinking of doing something to my FG 5.4L. I really like the sound of the Manta exhaust. Does the exhaust have a drone noise in the cabin on long trips? Just a bit worried about that.

  • @niceflicks
    @niceflicks Жыл бұрын

    It drones sometimes, 100KM/h up a slight incline, 1800RPM in lower gears up a hill - but nowhere near as badly as the XForce did - moderate throttle is just gnarly for all the right reasons

  • @Grechieman
    @Grechieman Жыл бұрын

    Sounds so bloody good man, I want to bugger off my KPM exhaust for a manta, is this the "loud" version?

  • @niceflicks
    @niceflicks Жыл бұрын

    Yes it's the loud version with stock cats, i was originally going for the KPM until i heard a couple of examples of the Manta - you won't be disappointed.

  • @MFP2241
    @MFP22414 жыл бұрын

    What kind of sheet metal cutter is this?

  • @mustangtony2933
    @mustangtony29335 жыл бұрын

    Yours is normal for these cars. don't rev it when cold...once it gets to operating temp..then send it.

  • @clmbn07
    @clmbn075 жыл бұрын

    I have the tick as well. Surprisingly I changed the oil to Motorcaft 5W30 and drove the hell out of it and the tick stopped. The only issue I have now is it sounds like the intake manifold runner control (IMRC) is not functioning properly as a I get a rattle that sounds like valve clatter when it’s cold at low RPMS.

  • @boostedlongbed1660
    @boostedlongbed16605 жыл бұрын

    Right there with ya.. It gets much worse. Subbed..

  • @underfedcoyote5.022
    @underfedcoyote5.0225 жыл бұрын

    You got it man thanks for joining team fords junk yard.

  • @AdamSmith-ps1ws
    @AdamSmith-ps1ws5 жыл бұрын

    Welcome to the 2018 GT tick club! I also have the same issue. No solution has been provided by ford. Anyways let us know if you take it to dealership. Did you already take it for diagnosis? Thanks

  • @niceflicks
    @niceflicks5 жыл бұрын

    Nah I haven't taken it in yet, soon though.

  • @Condor1970
    @Condor19705 жыл бұрын

    Welcome to the club. There's a whole slew of guys with this problem. Including me.

  • @Silenced_by_nazi_youtube
    @Silenced_by_nazi_youtube5 жыл бұрын

    Me too...but has it actually caused anyone problems yet?

  • @Condor1970
    @Condor19705 жыл бұрын

    @@Silenced_by_nazi_youtube Apparently there is a few that have had engines replaced because they supposedly found anything from cylinder scoring to bad journal bearings in the bottom end. Mine is kind of like yours and not that bad yet. I took it in, and they ran some diagnostics, but said it happens a lot. If it gets a lot worse, i'm taking it back to get it fixed. Most likely a new engine.

  • @niceflicks
    @niceflicks5 жыл бұрын

    @@Condor1970 The irony is there doesn't seem to be any specific fix, they're just picking parts out of the air, phasers, heads, blocks - and the "funny" part is a lot of the new or repaired engines are doing the same thing haha. I shouldn't laugh but it is a little amusing as obviously no one has any idea what is going on with the gen 3. I walked into this purchase well-researched on the topic, so i'm not that annoyed at this point.

  • @niceflicks
    @niceflicks13 жыл бұрын

    @AMFForumvideo Thanks mate, happy new year to you too!