Пікірлер

• 
  @AdrianAyaya-hy4gwАй бұрын

  Thanks needed this let me try then I'll review how it went

• 
  @vivianeoliveiravs39404 ай бұрын

  Obrigada por esse vídeo. Ganhou mais um inscrito . Abraços do Brasil .

• 
  @bernardmcmahon74345 ай бұрын

  Thanks for showing this. As a teacher, I can use this project. It's fun and educational. It's a much easier process than I've used making paper mache products in the past.

• 
  @storkbreath5 ай бұрын

  😂 that is fun!

• 
  @user-es4ji7tv1v6 ай бұрын

  ❤

• 
  @TheDingus77 ай бұрын

  This is epic

• 
  @feralfarm7 ай бұрын

  Hey thanks! I appreciate that😊

• 
  @feralfarm5 жыл бұрын

  I realized I forgot to enlarge the cut out of the threads in the lid. When you cut out threads to make a nut, we've found that if you increase the measurements by 1.5mm then the threads are able to accept the corresponding threads and still be tight. So if you're making this make sure you double check your measurements. It's at around the 9 minute mark where I forget to enlarge the cut out for the lid. Good luck and use research to back the second shape of your turbine. Everyone should have one pump housing and two turbines that will fit onto the 8mm ball point pen shaft so we can have two data points for testing efficiency of our pumps.

• 
  @feralfarm5 жыл бұрын

  SO, if my threads in the video are 35x35mm then they really should be 36.5 x 36.5 mm to allow a little wiggle room for it to thread on nice and snug.