Why do you flip your hood down every time? If you can't see with it on then you might wanna turn the brightness up or swap out your lense man. That's extremely inefficient. Just saying. I don't think you're adjusting your iron each time lol.
@IgnacioMartinez-or7yv11 ай бұрын
MUY PROFECIONALES EN. SU CHAMBA. FELICIDADES .
@bentleyfrancis1957 Жыл бұрын
What paint is that?
@andy6131 Жыл бұрын
That’s awesome. Good job and cool vid. Any tips on getting the louvres on so consistently? Looks fiddly
@andy6131 Жыл бұрын
Louvre/slats
@anamorales22322 жыл бұрын
Address please very nice
@bmak54052 жыл бұрын
Great looking rack. Where are you located?
@bcm3072 Жыл бұрын
Wyoming
@briantruck22842 жыл бұрын
💯
@MakeSomethingCNC2 жыл бұрын
Does this cause any cut issues with the watertable? I'm looking to just slap on a oxyfuel torch to my plasma and I have a watertable and I'm hoping it produces decent parts without damaging my table
@bcm3072 Жыл бұрын
No it is amazing with the water table. No cut issues in my experience
Пікірлер
Why do you flip your hood down every time? If you can't see with it on then you might wanna turn the brightness up or swap out your lense man. That's extremely inefficient. Just saying. I don't think you're adjusting your iron each time lol.
MUY PROFECIONALES EN. SU CHAMBA. FELICIDADES .
What paint is that?
That’s awesome. Good job and cool vid. Any tips on getting the louvres on so consistently? Looks fiddly
Louvre/slats
Address please very nice
Great looking rack. Where are you located?
Wyoming
💯
Does this cause any cut issues with the watertable? I'm looking to just slap on a oxyfuel torch to my plasma and I have a watertable and I'm hoping it produces decent parts without damaging my table
No it is amazing with the water table. No cut issues in my experience
What size tubing did you use?
2-1/2" tubing and 2" tubing