Пікірлер

• 
  @ianhutchinson206621 күн бұрын

  What are you trying to do?

• 
  @payitforward366521 күн бұрын

  I was getting ready to create some inside corners of a tongue and groove wall. I have a video of that on the channel

• 
  @jojocastillo644126 күн бұрын

  Thanks you

• 
  @onlyinparadise4613Ай бұрын

  Thanks for this video! Can you please link the LED equivalent for the parking light bulb? Thanks 🙏

• 
  @payitforward3665Ай бұрын

  Glad you liked it. I have not used the LEDs, but these seem like worth a try (and compatible per Amazon): Combriller 194 LED Bulb White 6000K Super Bright 168 2825 W5W T10 LED Bulbs with Protective Cover and Hollow Design Led Replacement Bulbs for Dome Map Door Courtesy Trunk Parking Lights, Pack of 2 a.co/d/90kcnYe

• 
  @onlyinparadise4613Ай бұрын

  @@payitforward3665 appreciate it! 👍😁

• 
  @Phoenix-ji7dy2 ай бұрын

  Thank you!

• 
  @dysfunctionalee33954 ай бұрын

  Your arm was in the way the whole time

• 
  @rickybobby72765 ай бұрын

  Those are adjustable snap ring pliers. You had them set for an internal snap ring, but the ball joint uses an external snap ring. You should set the pliers to external so that you can squeeze the pliers rather than push out.

• 
  @payitforward36655 ай бұрын

  Thanks a lot for that tip. Hoping I don't have to do that again in the next few months, but glad that it can help someone else who reads this!

• 
  @PatrickStone-bu2ve5 ай бұрын

  Music is on par

• 
  @arcuz78627 ай бұрын

  It's an electric car, it doesn't need any oil. Fake video.

• 
  @payitforward36656 ай бұрын

  It's a hybrid

• 
  @amitgaur98397 ай бұрын

  Helpful!

• 
  @amitgaur98397 ай бұрын

  Helpful!

• 
  @payitforward36657 ай бұрын

  Glad it was helpful!

• 
  @uli3119 Жыл бұрын

  Its offset which is what caught me offguard at first and made me doubt that it was the actual jack point. Also let me add that I got a 1.5 Ton Daytona from harbor for my Prius and it was too small for the job. I was changing my brakes and the 1.5 ton couldnt reach the aft jack point or should I say it reaches but the prius is so low and almost 3/4ths of the handle is under the car that its impossible to pump the jack up. The front jack point was simple to reach but even on level ground I pretty much maxed it out and managed to just barely get my 3 ton daytona jacks underneath the car. At max level it also looks sketch as hell cause the car is lopsided due to the jack point being offset. Just adding my two cents to help people out. Next time im buying a 3 ton jack. Which I tested out to finish off my brakes and it worked just fine.

• 
  @payitforward3665 Жыл бұрын

  I have only ever owned the 3 ton jack (Craftsman from when Sears used to exist), and it has always worked for Prius. Thanks for adding the info to help others!

• 
  @Phoenix-ji7dy2 ай бұрын

  Thank you both of you!

• 
  @twodogstar2565 Жыл бұрын

  You rock bro I couldn't find a clear picture or video of the front jacking point for my '97 honda accord. Thank you for sharing

• 
  @payitforward3665 Жыл бұрын

  Glad it helped