Пікірлер

• 
  @starlite528Ай бұрын

  Black Burst is the signal that feeds genlock inputs throughout a facility. It's a normal video signal that's just black.

• 
  @GodsTeethАй бұрын

  Thanks for the review! Seems like a great gift for my parents!

• 
  @tg9891Ай бұрын

  The Onkyo RZ-50’s App for smartphones will function as a fine remote. Don’t worry about the lightweight of the provided remote because the smartphone app once connected to your head unit will be more functional.

• 
  @abo0deMineCraftАй бұрын

  Is it still working? It seems heating the chips is not a real fix which can fail again sooner or later. A real fix is to replace the 90nm rsx to another 65nm or 40nm, but that cost a lot of money.

• 
  @gummyroachАй бұрын

  Yes, it is working great.

• 
  @mwizard14642 ай бұрын

  Your ordered an Asus ProArt. They all have Gold lettering. They sell White Gforce 4080's Just saying... RGB?? Connection? Huh?? Nice card for sure! Pull all the plastic covering off. Are you going to use a support for that card so it don't sag?

• 
  @user-fd3vm6gh6m2 ай бұрын

  great vibes great video

• 
  @ghers3 ай бұрын

  Great Av receiver, I love mine .. enjoy and don’t forget use Dirac EQ with Pc or laptop for better room calibration.

• 
  @BryanBortz4 ай бұрын

  Good job. Hardware repair is stressful.

• 
  @gummyroach3 ай бұрын

  Thanks!

• 
  @richjames25405 ай бұрын

  Had issues with vhs but never on beta or video 8. I thought it might be macrovision related.

• 
  @raphfung5 ай бұрын

  this my favourite video good job

• 
  @ejonesss5 ай бұрын

  i think the bending of the top of the image is caused by creasing or crinkling the top or bottom of the tape. during the 2000s the last gasp vcrs was notorious for creasing the top or bottom of the tape because i guess the guides was slightly mis aligned and would cause the tape to be folded against the top and bottom plates on the analog audio/control head or did not sit on the groove on the bottom of the drum body.

• 
  @gwenjarbothenickbeebiesfan20086 ай бұрын

  It's from 1990, according to Video Magazine.

• 
  @orihalcon86937 ай бұрын

  Vblank is probably vertical blanking - in other words that'll remove macrovision if turned on. RF in is used for dropout compensation and gets the RF signal directly from the video heads and that's how it knows when there's a signal drop to then compensate for it, most likely by replaying the line from the prior matching field or the line right above it. Usually there's a DOC sensitivity potentiometer as well that'll tell the unit at what level of RF signal is considered low enough to be considered a dropout. I haven't ever heard of anyone adding a DOC BNC to a consumer VCR, but it should be theoretically possible since it's most likely just an RF tap to the RF test point with a capacitor in series.

• 
  @protasov-by7 ай бұрын

  Hi, does this is full tbc, since frame and field tbc seems like different devices and some do both functionality etc

• 
  @TheRealHarrypm7 ай бұрын

  Its so nice we have full 4fsc frame sofware defined TBC today thanks to ld-decode and vhs-decode, with FM RF capture and preservation uprooting a market of inflation and outright missinformation.

• 
  @ThexthSurvivor8 ай бұрын

  Excellent video. Thanks for covering this.

• 
  @Yo-pz1em8 ай бұрын

  Hiya gummy. I’m banned from Reddit. I will come back next month. Please tell everyone I said hi

• 
  @colloidalsilverwater15ppm888 ай бұрын

  I use to make capture with help of Pixel View low budget TV card, no problems what you have.

• 
  @carollugo248910 ай бұрын

  1:20 u mentioned to book taxi a head of time, I’m curious, my stay at the maya is in November n transportation is included in the exclusive stay at maya paraíso, dud yours not include it?

• 
  @marshalleq11 ай бұрын

  I guess the guy at 40 mins wasn't captured with a tbc ;)

• 
  @binsworth Жыл бұрын

  Thanks for making this! I watched the whole thing over the course of the day, it was really cool seeing this

• 
  @fabrizioimperiale Жыл бұрын

  could you please add subtitles..

• 
  @WSNO Жыл бұрын

  This looked so fun when i first found this video, that i went out and bought one with all the special gizmos & the graphics tapes collection.

• 
  @timsmythfilmsandanimations2 жыл бұрын

  Thanks for making this video, very interesting and informative. I really like old equipment, and have many analog video and movie film cameras, and love shooting with them all, but like you, I will stick with the mac for editing. Thanks again.

• 
  @HansensUniverseT-A2 жыл бұрын

  Can we just take a moment and appreciate how amazing this technology is and the fact that it even works at all...

• 
  @chirik03 жыл бұрын

  Thank you for the information

• 
  @lordsmurf3 жыл бұрын

  The IVT-7 can be good in theory, but often is not. Far too often, these are abused, and yours appears to be no different. The signal gets wonky, and must be recalibrated, using the screws that you rightly mentioned should not be touched. All of the controls on these units are touchy, and it's hard to adjust. The now-noisy bad-bearing fan often needs to be removed. Heat is not a problem since you're unlikely to run this 24/7 as designed. Modding to remove the fan requires partial dismantling the unit, and isn't fun. This TBC is a large "pizza box" type unit, wider and longer than VCRs, with sharp corners and edges, so it will own any desk or cabinet where used. In general, I don't suggest these to casual or new users. You rarely see these units in decent shape, usually only as "parts only", again due to typical abuse from broadcast facilities.

• 
  @zhalberd3 жыл бұрын

  Thanks for making this video. Very clear and informative. I’d love to know more about the old YC cable. It’s not a DUB connector? Also, do you have any idea what could be causing this psychedelic pattern to emit from my VCR: kzread.info/dash/bejne/hWyNuY-clc_YYbg.html

• 
  @travellogger50803 жыл бұрын

  Why am I watching this. From the start to end???

• 
  @michaelkosciesza6453 жыл бұрын

  i may be able to scan a manual for ya!

• 
  @DB-nv5xl2 жыл бұрын

  Did you ever get the i.den ivt-7 tbc manual scanned?

• 
  @michaelkosciesza6452 жыл бұрын

  @@DB-nv5xl no, but I can do it today for ya.

• 
  @DB-nv5xl2 жыл бұрын

  That would be great, thank you very much

• 
  @michaelkosciesza6452 жыл бұрын

  @@DB-nv5xl kzread.info/dash/bejne/n6utp9iKmZy9qLg.html here is the video version of the manual. here is the pdf: drive.google.com/file/d/15YSo1yizt3IhXAXnxh3MZ11bb2bOUId0/view?usp=sharing

• 
  @drew-money2 жыл бұрын

  @@michaelkosciesza645 I'm considering buying one of these. Any chance you could post a link to the manual where we could download it or view?

• 
  @Capturing-Memories3 жыл бұрын

  You should have explained line TBC and frame TBC separately, They have different functions, It's more technical than what you can explain to the average person unfortunately.

• 
  @bobbydale19383 жыл бұрын

  thanks ,nice info !! i have one ,just learning

• 
  @gummyroach26533 жыл бұрын

  Glad you found it helpful.

• 
  @bobbydale19383 жыл бұрын

  @@gummyroach2653 yeah , iam trying to get copy of Manual, my unit is only producing black and white , won't play color , any ideas ? Thks

• 
  @colorizedenhanced-timeless59454 жыл бұрын

  Good morning, gummyroach. it is pretty vibrant video. thanks. :)

• 
  @gummyroach26533 жыл бұрын

  Thanks!

• 
  @obaysh27894 жыл бұрын

  Thank you sir! The only video on this unit on YT ❤

• 
  @gummyroach4 жыл бұрын

  You're welcome!

• 
  @guavaberry4 жыл бұрын

  Can’t get mine set up for some reason

• 
  @gummyroach4 жыл бұрын

  There are a small handful of VCRs that aren't detected by this unit. Have you tried a different VCR?

• 
  @JerryTerrifying4 жыл бұрын

  Found your channel looking up the videonics mx1. I have a video project that I think it would be perfect for a project. Interesting channel, subbed.

• 
  @ChristopherSobieniak4 жыл бұрын

  It might! It does seem pretty long a process getting the machines synced up and using multiple tapes and eyeing your cuts like that.

• 
  @gummyroach4 жыл бұрын

  Hi! This thing is very cumbersome and slow by today's standards. You're right; if the video was shot on multiple tapes and out of sequence (as most videos are!) it can take forever and a day for this editor to complete the job. Not the most time-saving, efficient gadget, but... it worked.

• 
  @JerryTerrifying4 жыл бұрын

  Awesome video brother.

• 
  @gummyroach4 жыл бұрын

  Thanks!!!

• 
  @ChristopherSobieniak4 жыл бұрын

  Nice piece of kit. I have a later Videonics "MX-1" Video Mixer myself.

• 
  @gummyroach4 жыл бұрын

  Cool! I have the videonics color equalizer. Back in the day, I wanted to get my hands on the video mixer, but that didn't happen. Now that we have digital editing, I don't really have a need for it.

• 
  @kvwebb7775 жыл бұрын

  I have one - never used it - seems archaic but if I were to see it does it have any value ?? God bless you brother, Keith

• 
  @gummyroach4 жыл бұрын

  You can find these gadgets on Ebay every once in a while. I don't know that you would get much $$ for it, as it is VERY obsolete. Why spend a week and a half editing with this clunker, when you can do it so much easier with a computer, right? It was a great unit for its time.