Пікірлер

• 
  @benwiggins616212 күн бұрын

  So what would be the solution for this fault? I have exactly the same issue, and hoping not to be ripped off by those that, as you say, pull out the parts catalogue and go crazy

• 
  @ams-mobileuk722612 күн бұрын

  This vehicle required a replacement vacuum pump, not to say that yours does with out carrying out a diagnosis first

• 
  @benwiggins616212 күн бұрын

  Of course. Thank you, my friend.

• 
  @NaZReD22 күн бұрын

  just did the same with my car, similar problem, only thing lighting up is the grey square box, i guess a relay? bottom right of your video here, but its situated bottom left of CJB, what is it? should it be hot?

• 
  @JavierCastro-by7ss23 күн бұрын

  Mine is focus 2013 se version, 5 speed manual one, cruise control works on 3rd gear, but not on 4th and 5th, I’m thinking of something to do with programming, issue started since I sent the car to the body shop

• 
  @NaZReD23 күн бұрын

  where about are you based fella? got a poorly jaguar XF parasitic battery drain, im Kidderminster, near Birmingham

• 
  @ams-mobileuk722612 күн бұрын

  We are located in Barton Le Clay in Bedfordshire. Bit far from you me thinks

• 
  @mindaugaspackevicius655723 күн бұрын

  Thanks!!

• 
  @vertex162Ай бұрын

  Good video

• 
  @kevintrussler8873Ай бұрын

  Can you plz help I have the same problem with my s max 2.2 except I put a new turbo on and did a eco map now it will only start if I probe the relay and help would be great Rhanks

• 
  @CharlieMac532 ай бұрын

  I think you may have solved my problem. My Galaxy wouldn't crank, but when I let it roll a bit it started. I assume therefore that it must be a dodgy starter motor, as did the garage. When I went to pick it up, it wouldn't start. The mechanic told me to press both the clutch and the brake. It started, but I told him I had never had to do this before and only needed to depress the clutch as normal. Having come across your video, I checked the drivers foot well and found it to be very wet. I will take it back to the garage and get them to investigate the corroded wire. I'm sure that is the problem. Cheers.

• 
  @davidwaters53483 ай бұрын

  Good diag

• 
  @jasonmoody96733 ай бұрын

  Yeah hi mate your videos very interesting I've just brought 2.2 and it's doing like the same but 1 minute it will start and then when I to turn it over I get nothing but when I get a jump start it will start straight away so I don't know if you know about that or if it could be the relay thank you

• 
  @ttalps20002 ай бұрын

  Did you get to the bottom of this?

• 
  @manmotor28893 ай бұрын

  Hi, I have a Ford Galaxy 2017 auto keyless stop/start system. Before the car started and ran ok, I did an oil,air, and fuel filler service when I about to start the car ,I had ignition, but know crank, brake peddle press and the green light is showing and the start button, when you press it, it flashes and don't start, check all fuses all ok , check starter relay ok , feed 12v to the starter ok, I even check. BCM that ok, now I'm stuck can some help me please

• 
  @tonyannand29993 ай бұрын

  Good to see you back very good diagnostic and more videos 🙏

• 
  @jamesbyrne96993 ай бұрын

  You deserve a lot more views. Your a really good diagnostic technician

• 
  @hellofriendhypnosis3 ай бұрын

  Im trading mine in. Mechanic cant find anything wrong. One day it works great, others days trouble starting, next day cuts off while driving.

• 
  @colin50644 ай бұрын

  Interssting video ,but why not just read the amps draw on the clamp meter display you should be able to see 55 amps on that?

• 
  @ams-mobileuk72264 ай бұрын

  I'd always check power/signal. With a injector pulling no current

• 
  @colin50644 ай бұрын

  Point taken but not evrybody has a Pico / assiloscope @@ams-mobileuk7226

• 
  @BrianVance-hn4fo4 ай бұрын

  There is a small oil filter in the head. You can google how to change it. If it is plugged with sludge the oil flow is limited. Change it periodically (and keep the oil clean) and you wont have this problem.

• 
  @homer10334 ай бұрын

  I have a vauxhall vivaro with a constant red immobiliser light, i've tried everything and i can't sort it... was working one day and then not the following day

• 
  @mattylowe713 ай бұрын

  Did you manage to solve this I have same problem even replaced ecu kit and still nothing

• 
  @homer10333 ай бұрын

  @@mattylowe71 hi matt yes I sorted mine out I think it was a combination of 2 things. I took the blue plug apart in the fusebox under the bonnet and found some contacts very corroded so cleaned up both parts with electrical cleaned and small wirebrush. Then I also changed the small ecu behind the gearstick as again a few corroded connectors. Small ecu cost 15 pound from ebay

• 
  @bobbyperu84144 ай бұрын

  .. do you know part nr ?

• 
  @user-kd3gi1xu1h4 ай бұрын

  Thanks this help sort my master out .

• 
  @martin-jj9pe5 ай бұрын

  Long way around on a fiat just go from the negative on the battery to a metal on the engine with jumper cable

• 
  @ams-mobileuk72265 ай бұрын

  Testing with a jump lead is a poor way to carry out that test as depending on the quality of the jump lead it still may not start. Look up the video super mario diagnostics did on testing earth faults. It explains it quite well

• 
  @sabregold76575 ай бұрын

  Thank you for this

• 
  @michaeloreilly23885 ай бұрын

  You legend! This was the problem exactly and due to a water spillage a few weeks previously. Thank you!!! For reference for others. The weird thing about the problem I was having is that it would start but needed to have both brake and clutch depressed and 2 pushes of the start button. Now all back to normal. Thank you!!!

• 
  @iancutts46526 ай бұрын

  Non start stop master cylinder fitted???

• 
  @user-tk9ql8rh4z6 ай бұрын

  Do you cover denton mancher

• 
  @ams-mobileuk72266 ай бұрын

  Hi there. Unfortunately we don't cover there. We are based in Bedfordshire

• 
  @hughwilson34666 ай бұрын

  Hopefully you are still monitoring the comments.... I've got 95% of the same conditions featured here, right down to the previous Aircon leak. The 5% difference is that when I trigger the start button... The dash shows "press clutch to start" and that dismisses when I press the clutch (But no response from the engine) Does that mean my clutch wire is likely ok or does that switch feed different modules and there could still be a break? Appreciate your thoughts before I get to ripping it out!

• 
  @ams-mobileuk72266 ай бұрын

  Hi. I'd say if the clutch message goes out when you press the clutch then it5 is probably ok, if the vehicle is not cranking you need to start at the starter motor & work back from there

• 
  @hughwilson34665 ай бұрын

  @@ams-mobileuk7226 Your video has saved another one.... just reporting back to say that.. after noting the clutch notice on dash was actually intermittent, I had a look at the wiring in question.. and bingo! I actually have no idea what Ford were thinking with this connection, they could have added 50p to the build cost and done it in so many better ways.

• 
  @abdulhamza9207 ай бұрын

  brilliant video good to hear you pls send me a link to reg for waring daigram pls feed me back thanks a lot

• 
  @360designs47 ай бұрын

  So what was the drain caused by?

• 
  @TheValydj8 ай бұрын

  🙏🏻 thank you

• 
  @TheFuneralDirector8 ай бұрын

  Thanks for explaining the wave form on the scope

• 
  @RobertJohnson-kv6dr8 ай бұрын

  Good luck in your new adventure

• 
  @johndutton28959 ай бұрын

  Best of luck, keep us updated 👍

• 
  @benblank16079 ай бұрын

  Good luck mate, cleanest it will ever be 😂

• 
  @davidbonnett54419 ай бұрын

  Good luck

• 
  @5e34nut10 ай бұрын

  Brilliantly tutorial mate

• 
  @colinblackwell505910 ай бұрын

  hi i want to know what can be causing the problem with my brother tony he has a jagaur XF and 20 litre diesel and it is a M reg 65 reg and the battery has draining and some times wont start and i want to know what can cause it.

• 
  @homesteadandvideo10 ай бұрын

  Great video

• 
  @dogrussell53510 ай бұрын

  Have the exact same issue on dash but fuse isnt blown. Where would you be looking after?. Tia.

• 
  @ams-mobileuk722610 ай бұрын

  Have you carried out a code scan. Do you get comms with the engine computer?

• 
  @dogrussell53510 ай бұрын

  @@ams-mobileuk7226 cheers for the reply. I had it scanned a while ago and the only codes were throttle position and something to do with glow plugs. Only thing I noticed before it died was a abs and service light came on then off again in a minute or so whilst driving. Checked all fuses and relays not checked wiring looms yet. Did find the earth to gearbox was rusted but have sorted that. Also three mechanics have gibmving up on it. Dont suppose your in cornwall?.

• 
  @ams-mobileuk722610 ай бұрын

  @@dogrussell535 I'm afraid i am not. I am based in Bedfordshire

• 
  @tomm384810 ай бұрын

  Hi, very good info. I've a 2008 Renault Master wondering where you got the details wiring diagram from as struggling to find one online.

• 
  @ams-mobileuk722610 ай бұрын

  Hi Tom. I pay a subscription for technical data. I use e3 technical & haynes pro, and if they dont have what I need then i get info direct from the manufacturer

• 
  @tomm384810 ай бұрын

  @@ams-mobileuk7226 Thanks for reply

• 
  @mac74lee11 ай бұрын

  Brilliant best and simple explanation video seen in a while. Do more pal

• 
  @ThundaAaAaAaAaAh11 ай бұрын

  THANK YOU!!!!!!!!!!!!!!!!!!!!!!!!!!!!

• 
  @ajjuliajewellery251511 ай бұрын

  Hi, I have question. Mine does not start because the bottom contact which is ne relay in the fuse box do not have a ground, it is missing. Where should I look for to find grounding.

• 
  @paulogomes503211 ай бұрын

  Seen most of your videos, got a good one for you…. My Inlaw has jag xf battery drains, BUT also powers goes on and off on its own??? Any ideas… Sent from my iPhone

• 
  @Krume7911 ай бұрын

  Excellent video, well done. I'm having a problem on the same vehicle Clio 1.2 16V with a pin number 20, it's for AC control to rise the RPM's when AC is turned on, but there is no voltage. The AC works perfectly with direct 12V. I like to put direct currency on pin 20 but i do not now exactly voltage for this pin od the ECU. Does it 12v ? Pls a need help to check and resolve this issue

• 
  @robjames292 Жыл бұрын

  Brilliant video nice to see proper diagnostic, step by step, and keep them coming

• 
  @froggy0162 Жыл бұрын

  Sloppy clutch job… Didn’t bother cleaning anything by the looks of it.

• 
  @argis201 Жыл бұрын

  Please help, mine does that, but.... After couple time of pressing the start button, it finally starting the car. And this accurs not every start of the car. May it be just. Relay.?

• 
  @ams-mobileuk7226 Жыл бұрын

  There is a number of things that could cause this. Best thing to do is find a reputable garage near you & let them take a look. Depending on how intermittent the fault is, it could make it difficult to track down, as the fault needs to replicated when the technician has it

• 
  @DJ-tn7vj Жыл бұрын

  Hi was this a super charge Nissan Note?

• 
  @inmyopinion_talk Жыл бұрын

  What type of tool did you use to get an idea of the origin of the drain?

• 
  @ams-mobileuk7226 Жыл бұрын

  It was a snapon thermal imager and a multimeter I used to track down the drain

• 
  @robertbrazier6356 Жыл бұрын

  Need with my s max looked at starts then cuts out low fuel pressure I’m in Brentwood

• 
  @ams-mobileuk7226 Жыл бұрын

  Hi Robert. I don't cover Brentwood. I'm sure you'll be able to find a good diagnostic garage near you

• 
  @Onyxracesuspension Жыл бұрын

  Hi mate I have a 2008 2.5dci traffic, I have the same problem with the immobiliser light staying on.. although my engine management is coming on.. I’m ve had a new key coded.. currently for the loom exposed, checked the ecu terminals etc but now I’m stumped.. are you able To tell me what relays go we’re as I’m wondering if one has failed but I have no idea what works what. Many thanks

• 
  @danielwalker339610 ай бұрын

  hi what did this turn out to be just ive go same year and same problem now