Пікірлер

• 
  @N0-id843 күн бұрын

  $400 ??? Sheesh

• 
  @Cowboymecanic4 күн бұрын

  Did u keep drive shaft same or modify? What rear end u have.. I have 1980 4 door te72 and wanna do this swapp

• 
  @dayliefr66276 күн бұрын

  Great video. Clears up alot of the misinformation on forums and hard to find answers reall good video and a well spent 30 minutes for me

• 
  @occasx9 күн бұрын

  how does it sound? these cheap Chinese units often sound worse than the original unit.

• 
  @slightlymodified5019 күн бұрын

  @@occasx they sound about the same. You have to leave your OEM amp in or your tweeters on the dash stop working.

• 
  @mikegebhard9010 күн бұрын

  Did you have any wiring issues? I've got an 07 with a 14 motor also, and I just can not got the damn thing to fire. Makes no sense. Did any wiring need to be switched or was it plug and play?

• 
  @slightlymodified50110 күн бұрын

  @@mikegebhard90 Nope, 100% plug and play. However, I had to buy and install the automatic compression release harness. I never even touched the starter button after I finished the swap. The tuner did the rest.

• 
  @mikegebhard909 күн бұрын

  @slightlymodified501 good to know, I fabbed an ACR harness as well. Can't get it to fire, but if i flip the plug wires it backfires through the intake. Everyone is throwing their guess in which really isn't helping, lots say oh that motor won't work with the 07 harness, the 07 coil is wrong, the intake wont work etc, yet your swap obviously proves that wrong. I did cams on mine so it's almost gotta be a timing/ pushrod thing then.

• 
  @domvalencia687211 күн бұрын

  Interested in selling? im in socal

• 
  @organicvids16 күн бұрын

  Update? How is it? Any complaints?

• 
  @slightlymodified50112 күн бұрын

  The screen went out a while back but the seller sent me a new screen and videos on how to change it. Been fine after that. Car got totaled a few months back and we were unable to remove the stereo. But we loved it.

• 
  @organicvids12 күн бұрын

  @@slightlymodified501 thanks for response

• 
  @tslaten24119 күн бұрын

  Where did you get the Lexus branded bezel?

• 
  @slightlymodified50112 күн бұрын

  Came with the stereo

• 
  @tslaten24110 күн бұрын

  @@slightlymodified501 Thanks!

• 
  @organicvids26 күн бұрын

  Mine also 2012 bt is junk

• 
  @lexiaontubeАй бұрын

  Does it still run with the el cheapo pump ?

• 
  @DLAMedia46Ай бұрын

  Well that’s a different way of removing the bumper. Much less work if you remove just the 2 bolts from underneath into the crash bar.. then the whole thing comes off. Both ways work tho tbf 🤷🏻‍♂️🤘🏼

• 
  @johnzasada5573Ай бұрын

  Hey thanks man very helpful

• 
  @solaryellowis3007Ай бұрын

  I have one of these and didnt even think of jz swapping it.

• 
  @thegillfamily8704Ай бұрын

  yoooooooo!!! bro! your videos are amazing! You are a JZ guru, my man! Hope the parts you got from me did you some good. Your work is amazing!!! Build my Sup, Please! 😜😆

• 
  @slightlymodified501Ай бұрын

  @@thegillfamily8704 yoyoyo! Sell me your supra!!!! Hahaha. Yea. I actually used every single part I got from you except the manifold…. But sadly the ecu was no good so I had to get another. The turbo sounds and feels great!

• 
  @thegillfamily8704Ай бұрын

  @@slightlymodified501 I'm sorry about that. HMU if you have my #. This video makes me happy. Tried to DM you here but I can't find a way. Ill refund you for that ECU, or I actually might have another one if you need it, brother. Let me know if i could help with anything else, my dude. BTW, I could get you a Supra, just not my current one. LOL. I meeeeannnnn, you can Take my Sup and I'll pay for your magic....😉

• 
  @estevanurrutia2007Ай бұрын

  Amazing 👑👑👑👑👑🔥🔥🔥🔥🔥🔥🔥🔥🔥

• 
  @احمدالصجريАй бұрын

  hi can I now the wep set that can get wiring diagram for 2.5 1jz fse ecu engine

• 
  @mhellcess4532Ай бұрын

  Nice video man do you have a link? Thanks

• 
  @mitchelsmith7076Ай бұрын

  :[Gratitude brother got a bent frame about swapping out getting ready to pull the 103 twin cam].

• 
  @omardelarosa4899Ай бұрын

  Nice video

• 
  @phillipcorpusАй бұрын

  Loved the video! I just bought my ct200 a couple days ago and cannot wait to upgrade to this. The link to Aliexpress have so many models. Can you suggest or recommend which one is the best? Thanks

• 
  @MikivliАй бұрын

  how expensive was the right hand drive conversion?

• 
  @johncerdena1421Ай бұрын

  Just got my 2015 yesterday! I cant wait to upgrade mine to this

• 
  @randyrebelez58842 ай бұрын

  Pretty dumb not wearing life jackets!

• 
  @slightlymodified5012 ай бұрын

  Im still here.

• 
  @randyrebelez58842 ай бұрын

  Do you really want to advocate not wearing a life jacket while in a boat? @@slightlymodified501

• 
  @ignacioandresplariedemann76502 ай бұрын

  Thanks! Works for ct200 2011?

• 
  @larskarlsson40842 ай бұрын

  What is the lowering specs? 60/40?

• 
  @ibneyslife422 ай бұрын

  Niceee mann🔥👌

• 
  @Bismillah38092 ай бұрын

  Keren banget

• 
  @LilDil972 ай бұрын

  Loving your videos at the moment as I’m doing a similar setup. Is this still with the 350hp setup on stock ECU?

• 
  @slightlymodified5012 ай бұрын

  Yup. I swapped to a small turbo about a year ago for a more responsive set up

• 
  @LilDil972 ай бұрын

  Thanks for the quick reply, which turbo did you switch to for response? I’m using a G25 660

• 
  @slightlymodified5012 ай бұрын

  @@LilDil97 That should spool Up nice. I put a borgwarner s257sxe

• 
  @LilDil9713 күн бұрын

  @@slightlymodified501 is there a different platform I can dm you on to discuss your setup? Mine is now running but super laggy even with the small turbo.

• 
  @333jmz2 ай бұрын

  thanks for that video now i gotta get it done..

• 
  @Juju_Zee2 ай бұрын

  Thanks bro this video is really helpful

• 
  @mikeknudsen17642 ай бұрын

  Nice to see a actual tech post a very detailed and opinionated video. Great job!

• 
  @998RC2 ай бұрын

  What does it mean if I see 4v at the pump before even putting the key into the ignition. Then 12v when turning it on for a couple seconds?

• 
  @alexcosentino55892 ай бұрын

  Did you have to pull the oil pan

• 
  @slightlymodified501Ай бұрын

  I did not

• 
  @nunyabizznizz73262 ай бұрын

  was this a havasu boat before you bought it? think i used to see it on palo verde, below the high school for years, in a car port

• 
  @slightlymodified5012 ай бұрын

  Its been a Havasu boat for probably the last 10 years. It went a few owners rapidly at one point

• 
  @murphyitsyou91692 ай бұрын

  Very helpful video. I’m going to be tackling my motor swap and this made me feel confident I can get it done myself. Got my Harley tuned at Thompson myself in Gardena. really good tuner 👌🏽👌🏽

• 
  @ricardowilliams14662 ай бұрын

  Hey, how’s it going buddy I was watching you video. I also use Jean for my bike. He does a pretty good job. Since you have the 103 if you’re not into racing and you want a little bit more power what I did on my 103 are use the 255 Screamin eagle cam That cam comes in the Harley Davidson 110 Screamin eagle engine. It is a great highway cam and it’s expensive to buy when I did my first tune with Jean. I had that cam with the D&D when he was done dying on the bike. It put out 105 on torque and 108 on a horsepower. By the way, my hair support and polish as well.

• 
  @jenstori57462 ай бұрын

  What size bolts did u use for engine stand ?

• 
  @slightlymodified5012 ай бұрын

  M12x1.25. The length varies depending on your stand. If you get them a little too long, you can use washers to make it perfect.

• 
  @THE46GUY2 ай бұрын

  Very nice work!

• 
  @wheelsonfire39452 ай бұрын

  Im appreciate the video and Props to you🎉 quick side note: the Lexus Bluetooth has 2 ways to pair and if you pair to it the 1st way, then your phone will not literally connect on Phone calls and only w/ Music….. But hey!!!! Y’all got a dope new head unit!!!!!

• 
  @jenstori57462 ай бұрын

  Do u mean where the folk is ?

• 
  @williamlarese30102 ай бұрын

  Put some walls up n nobody will be able to see it 😂

• 
  @jenstori57462 ай бұрын

  1jz gte vvti with r154

• 
  @slightlymodified5012 ай бұрын

  Theres a clip on the inside where the clutch is. After you remove the slave, look inside and remove the clip.

• 
  @jenstori57462 ай бұрын

  How do you remove the transmission from engine having a hard time…

• 
  @slightlymodified5012 ай бұрын

  Factory BMW trans? Or Toyota?

• 
  @christopherfonseca40623 ай бұрын

  Do you have to buy new fog lights ? Can’t you use the original ones ?

• 
  @raysegura66693 ай бұрын

  Shit man good job 👏🏼

• 
  @davidncw46133 ай бұрын

  cool ty

• 
  @cristhegearmonkey3 ай бұрын

  If you ever wanted to you can always put some trim and quarter round to cover up that last little bit of vapor barrier if the blue bothers you and you can paint your quarter round amd trim whatever color you want 😉 im sure yk. Looks awesome though brother SUBSCRIBED your shed is SICK

• 
  @tommyho64373 ай бұрын

  Kinda confuse. U didn’t really show how u hook up the radio. U said when u hook up the connection and there’s no sound due to factory amp. How do u do that. What’s the module, does it comes with it?

• 
  @luisrios70583 ай бұрын

  Sick!!! Love from Norwalk lol

• 
  @aapddd3 ай бұрын

  Nice Harley man !

• 
  @slightlymodified5013 ай бұрын

  Thanks you. Cooked the engine a while back. Just got it back on the road. Feels good!