Пікірлер

• 
  @obisvanainobis9950Ай бұрын

  Most important part cut out for me, how did you remove the clutch drum????

• 
  @enzocardozo4616 ай бұрын

  Más lento por favor

• 
  @Nathan-lt6bw Жыл бұрын

  looks like it came from a haunted house

• 
  @nikolasimic9330 Жыл бұрын

  Svaka čast dobar je trimer sa ❤❤❤

• 
  @turd6776 Жыл бұрын

  Good one 😊

• 
  @atjalex1 Жыл бұрын

  good video but it was too fast and I couldn't follow you

• 
  @codygerardot5446 Жыл бұрын

  Super helpful!

• 
  @jonlambshead5115 Жыл бұрын

  Good Job

• 
  @sadis9435 Жыл бұрын

  Good Job

• 
  @erinmanners50332 жыл бұрын

  awesome work ........this would take me a month to complete

• 
  @tc36032 жыл бұрын

  Love Ur strimmer stand. You are a good operator

• 
  @gardenrepaircy20192 жыл бұрын

  As it was my first video clearly there are mistakes and confusion.i would upload a more simplified and detailed process in the future of the same model.!

• 
  @exCR-it3ex2 жыл бұрын

  I am going to modify some regular pliers with extensions by cutting off the tips and welding in longer arms. That design of the housing could have been simplified if stihl thought it through. Thanks for the upload. But yea it says Bearing replacement in the title so it should of had the removal and installation included. Just saying.

• 
  @exCR-it3ex2 жыл бұрын

  You skipped the most important part. Getting the snap ring off. Is there a special tool. I don't have long snap ring pliers

• 
  @gardenrepaircy20192 жыл бұрын

  Well i had to trim the edges of my plier with a grinder :/

• 
  @pabloperlo44792 жыл бұрын

  Beauty work

• 
  @winstonclarke92212 жыл бұрын

  This video is a waste like you were running a race.

• 
  @rennieramdhan23182 жыл бұрын

  You never showed how the bearing was removed... that was the main part...waste of time

• 
  @theactualsalvagedrover2 жыл бұрын

  You don’t show HOW you REPLACE the bad bearings though. How did you press them from the housing?

• 
  @agapitorodriguez4142 жыл бұрын

  Niiiiiiiceeeeeeeeee

• 
  @andymumford39693 жыл бұрын

  Undone four bolts from housing to engine and still wouldn't separate???????

• 
  @gardenrepaircy20193 жыл бұрын

  Yea i think it was the first time been seperated since factory

• 
  @andymumford39693 жыл бұрын

  @@gardenrepaircy2019 hi so am I correct it's just the four bolts that hold it in place so if that's the case a (gentle) tap should d free it