Пікірлер

• 
  @Rawk_One3 күн бұрын

  You gave me a clear hose?

• 
  @yuidfbse24 күн бұрын

  Great video thank you very much! One question, do you know where the coolant bleed valve/plug is on the Diesel CDI engine? I did a cooling flush on my 2009 ForTwo CDI but could not find the bleed point location that I know should be near the cylinder head to bleed the air out of the tubing. Now the car is overheating with the water not circulating and I guess full of air pockets everywhere. I've searched all over the Internet and the all the information available is only for the gasoline engine not the diesel. Thank you very much😊😊😊

• 
  @eriksaenz2123 күн бұрын

  @@yuidfbse unfortunately I never had a diesel Engine smart

• 
  @eriksaenz2123 күн бұрын

  @@yuidfbse unfortunately I never had a Diesel one

• 
  @nizamahmed507327 күн бұрын

  I've emailed them now let's see. I see some more mods like the steering wheel cover. Light up vents and a larger screen. 👀

• 
  @ronalvey103Ай бұрын

  Why did you do this video vertically?

• 
  @kayali88422 ай бұрын

  Did u fix the problem? I’m having same as u

• 
  @eriksaenz212 ай бұрын

  You can buy a new actuator on Amazon if the actuator is the problem. If that didn’t fix it then it could be your clutch that is gone but there is also a chance that is the transmission shifter motor which I put a video on my channel . In my case it was the clutch after replacing the actuator and shifter motor .

• 
  @kayali88422 ай бұрын

  @@eriksaenz21 I took off the actuator it was rust and white dried out powder in there, was jammed. I I ordered a new actuator but aftermarket part, hope it works

• 
  @GXSPOD3 ай бұрын

  can you tell me the part number of the fuse box cover, I just don't have it and I want to buy and put it on

• 
  @ST-ug1fo3 ай бұрын

  Link for switch pls. Exl model

• 
  @michaelnowak98133 ай бұрын

  Hi my friend best regards from Germany thanks for this video I was looking for everything but not find the error thank you so much

• 
  @javierperez52233 ай бұрын

  Thank you for sharing this video. It was really helpful!

• 
  @eriksaenz213 ай бұрын

  Glad it was helpful!

• 
  @robertoproietti49243 ай бұрын

  Grazie mille per il suo video, avevo propio bisogno di capire come si smontava questa scatola, ho ordinato un tubo diretto in gomma e quindi devo capire come smontare il risonatore))) grazie mille!!

• 
  @thomasrhett63 ай бұрын

  Man are you serious. Its uh number 6 and 8? The harness pins are 1-6! There are only 6 there!

• 
  @xjinit4 ай бұрын

  Hey, was this a cars2go smart?

• 
  @valentindz27004 ай бұрын

  Hello

• 
  @user-is6tp9kl9i5 ай бұрын

  I buy the car in the action the battery is off how I can programmed

• 
  @eriksaenz213 ай бұрын

  No need to program

• 
  @honda1169695 ай бұрын

  I just fucked up mine by draining out the old ⛽ & I guess I knocked the wire loose. Fuck I'm so 😡! Good video bro

• 
  @dallasb12245 ай бұрын

  I haven't tried yet but if it does I'll be so thankful

• 
  @petef.hagwash37346 ай бұрын

  I saw a video where he used a paper clip to connect the black wire with the White and green wire in the pannel you replaced .. and it workd.

• 
  @ST-ug1fo3 ай бұрын

  It will draw power from battery even when car is off

• 
  @chiupangkwan43058 ай бұрын

  Damn...i wish i saw this earlier, bring back to the dealer cost me $1200. The mechanic told me the same thing, He changed the OEM battery and wiper motor, but i know the problem is the fuse...

• 
  @eriksaenz218 ай бұрын

  Sorry bro I almost spent $500 on a new bcm luckily I found it before the appointment came

• 
  @eriksaenz213 ай бұрын

  Mercedes has no clue about these cars don’t take them there . Find a Renault mechanic or Japanese

• 
  @FREDERICPIERSON8 ай бұрын

  Thanks for your video

• 
  @valoremilano5428 ай бұрын

  Is this for a 2009 s550 Mercedes

• 
  @Nicolas_Sellas9 ай бұрын

  This is the engine ecu?

• 
  @sabycruz387111 ай бұрын

  Hi i have some problem with my smart 451 2010 the car started but don move when I put to from or revers only is in neutral N I put R or D and speedometer only can si P and N and the car don’t move some idea what can I do I put another transmission and other actuator and is the same

• 
  @awesomein360tiagowolf411 ай бұрын

  Thanks for sharing. I had seen the installation before on a pdf sheet butnin video is always better

• 
  @AutoAndChill Жыл бұрын

  What are you doing with the hose at the end?

• 
  @eriksaenz219 ай бұрын

  You are not losing coolant it goes in cycles until you don’t see more bubbles then put everything back together.

• 
  @littlerhino26116 ай бұрын

  Whats the problem when the car doing that

• 
  @littlerhino26116 ай бұрын

  I have the same problem right now with my smart car

• 
  @nathanielbachelier32666 ай бұрын

  What size hose do I need?

• 
  @joecox9958 Жыл бұрын

  thanks would you mind text the steps clearly?

• 
  @piotrwolny578 Жыл бұрын

  I have problem with active radar

• 
  @garealtours Жыл бұрын

  It is really helpful to have the sizes included in your video; great job! My concern, which brought me here, was getting all the other stuff out of the way, but that bolt on the bottom would have been a surprise. Thanks for making this! :)

• 
  @eriksaenz21 Жыл бұрын

  Read the description on the video and ask questions hope I can help

• 
  @petarilievski4890 Жыл бұрын

  I needed this

• 
  @petarilievski4890 Жыл бұрын

  Thanks bro

• 
  @eriksaenz21 Жыл бұрын

  Im glad it helped you

• 
  @duplo. Жыл бұрын

  Great

• 
  @superblackman99 Жыл бұрын

  Ive got the same problem now, could you share some pictures at where exactly the temprature sensor is i couldnt see it on the video. Thanks

• 
  @eriksaenz21 Жыл бұрын

  Did you find it ? Sorry for the late reply

• 
  @KevinKashLopez Жыл бұрын

  Did yours work without connecting the black wire to a ground source?

• 
  @petefalvai5130 Жыл бұрын

  Thanks for sharing 👍

• 
  @eriksaenz21 Жыл бұрын

  No problem 👍

• 
  @evilutionltd Жыл бұрын

  Always disconnect the ground 1st and reconnect the ground last.

• 
  @redhatt69 Жыл бұрын

  I have the 2019 model and I did not have to take off any of the fairing or plastics. The connector is tucked away and can be difficult to locate but once you find it, you can simply plug into it. I used the outlet found on Aliexpress that comes with the Honda connector.

• 
  @mravec972 жыл бұрын

  Thank you. It helps a lot. That 2 rubbers was holding it so hard... It was struggle to pull it out

• 
  @tyomikshkolnik79882 жыл бұрын

  How did you get the wire to the other side of the car (to the stereo)? Through the headliner? How did you get it to the stereo from the headliner?

• 
  @jzeman2 жыл бұрын

  I got my backup camera wired to the back window (2008 Mazda5), but how did you get the light assembly off the car? I unscrewed it (popped the two covers and removed two screws) and pulled but it didn't want to come off, didn't want to break the light assembly

• 
  @istominmusic2 жыл бұрын

  Как вы открыли крышку задней двери? Я не могу найти способ, что бы провести провод...

• 
  @eulysses2 жыл бұрын

  Were you able to wire your camera? I am also not sure how to run the camera wire inside the tailgate.

• 
  @eriksaenz21 Жыл бұрын

  @@eulysses kzread.inforPP87YjdKX0?feature=share

• 
  @eriksaenz21 Жыл бұрын

  @@eulysses kzread.inforPP87YjdKX0?feature=share

• 
  @eriksaenz213 жыл бұрын

  Anyone ? What’s this noise when accelerating only ?

• 
  @eriksaenz212 жыл бұрын

  Solved! Heat shield was lose

• 
  @krzypo65113 жыл бұрын

  At Ebay you can find plug&play set USB charger QC3.0 with voltmeter and Genuine plug www.ebay.com/sch/m.html?_ssn=sanchomapento&_osacat=0&_armrs=1&_odkw=&_from=R40&_trksid=p2046732.m570.l1313&_nkw=honda&_sacat=0

• 
  @nickmc063 жыл бұрын

  Thanks for doing this video. What USB Adapter are you using to charge your phone/device? I've bought a couple on amazon, but they don't seem to be getting power. But I double checked the Honda 12V socket and it seems to be getting proper voltage. It just almost seems like it is too deep for the USB adapters I purchased. Thank you!

• 
  @TheRideandPlace3 жыл бұрын

  Nice video. But you actually don't need to touch the left side. The right side bolt alone is enough to loosen and tighten. Cheers!

• 
  @intellectualkshatriya30463 жыл бұрын

  Bro u r great , I was struggling for the same reason , and I couldn’t find any related videos , I have Honda Cb 125e , it’s completely same grip , I am really happy. Thanks again 👍🍺

• 
  @dhannylb3 жыл бұрын

  Hi. How did you remove the black dummy connector?

• 
  @eriksaenz213 жыл бұрын

  Sorry for the late reply, it has a system like the one u see on a faucet. I ring underneath u spin that out underneath first 👍

• 
  @vaibhavxp4 жыл бұрын

  Thank you very much for this video. Was badly struggling to remove the bar ends on my 19 CB500X. This truly helped. Cheers brother.

• 
  @deanostovic98734 жыл бұрын

  How long must be the cable? From the USB socket to the original Honda connector?

• 
  @phuketbungalowinfo27574 жыл бұрын

  AliExpress 2-10 USD .. i think they are all the same, just sold more expensive. Btw, you can find the same connection on the CRF 250 Rally direct behind the front fairing left side

• 
  @johnmfjw4 жыл бұрын

  I the Honda socket seems to be more water resistant compared to the ebay ones.

• 
  @jeison93663 жыл бұрын

  Can you sent me the link from the Aliexpress?

• 
  @phuketbungalowinfo2757 Жыл бұрын

  @@johnmfjw i tape everything anyways :) ...and btw, over the years i learnd filling my extra things with silicone and hotglue, NOW they hold forever :D

• 
  @Arianayjoseph4 жыл бұрын

  Can you tell me where is located the camera

• 
  @eriksaenz214 жыл бұрын

  Sorry I didn’t get the question. Camera in this case was installed at the top of the back door since it would be more work to put it by the plate as most cars

• 
  @karenwarvi5317 Жыл бұрын

  Do you still have a good view for backing up? Like if you had put it into the license plate area.. which would have required removing the back hatch wouldn't it?

• 
  @eriksaenz21 Жыл бұрын

  @@karenwarvi5317 I sold the car long ago I placed it at the top and yes I actually liked it a lot more you can see far back and also your bumper when u park in narrow spaces

• 
  @karenwarvi5317 Жыл бұрын

  @erik saenz hey Erik, the shop who are installing my camera back up were worried they might have to remove the back hatch to install the camera but I had remembered your video.. didn't you run the wires through the wiring harness on inside trim to the window? IS IT POSSIBLE FOR YOU TO SEND ME A LINK TO THE VIDEO YOU MADE SHOWING THE ROUTE TO THE CAMERA PLACEMENT SO THEY CAN USE YOUR VIDEO AS A GUIDE, WITHOUT REMOVING THE BACK HATCH.. your help would be much appreciated. They have already installed the front camera and stereo just awaiting Rear camera install after New years... Thank you for your very kind reply after so long but I had remembered your original video and hoped you might read this new post. I can send you my info if you can send me a link so they can see how you routed the wiring without removing the hatch back. Thanks!

• 
  @eriksaenz21 Жыл бұрын

  @@karenwarvi5317 here is the link I just made. kzread.inforPP87YjdKX0?feature=share