Пікірлер

• 
  @hassanhas47749 ай бұрын

  السلام عليكم كيف احصل على ملف65سنتمتر gpx500وشكرا

• 
  @recepsemiz7124 Жыл бұрын

  hello, can you give your e-mail address?

• 
  @user-id8ub4ub7d Жыл бұрын

  👏👏👏👏

• 
  @qedmetaldetectors49722 жыл бұрын

  Compare with this video kzread.info/dash/bejne/dZmJmLeGady-hqw.html The QED is a bit over 1/4 the price.

• 
  @ygrene1012 жыл бұрын

  So you couldn't show how you got it out?

• 
  @rayrizzle90952 жыл бұрын

  Right!

• 
  @tolgakarabulut82872 жыл бұрын

  Good morning and thank you for this valuable information and I have a question please exists on this . _( How many turns are in the grand mono coil _18 inch _ and wire diameter user (gpx 5000) _and how it is linked the wires in numbers? ...my respects

• 
  @RafaelDavidpersonalpage2 жыл бұрын

  I tried this and it worked for about a minute, apparently it just resets the cruise control computer and works for about a minute and then goes back to no turning on

• 
  @MetalDetectorscom2 жыл бұрын

  Still working fine for me

• 
  @EarthSurferUSA11 ай бұрын

  Curise control not turning on? Try beeping the horn. Works every time for my 2013 Wrangler. New electronics are such fun.

• 
  @ha.farz.29533 жыл бұрын

  Hello dear sir thanks for your interesting video. Had you used 8R speaker?

• 
  @r0bstewart013 жыл бұрын

  Thanks for this. Saved me a few dollars! Very informative.

• 
  @rc3d4903 жыл бұрын

  the Chanel are death? n don't have content about metal detectors

• 
  @pitercalvin20664 жыл бұрын

  Minipulse very very bad for gold nuggett

• 
  @kevinc32694 жыл бұрын

  Thank you. Cruise was not turning on and cleaned like you showed and it worked. Very easy fix.

• 
  @MrYupik5 жыл бұрын

  I have a yellow alarm saying "FCW OFF" for some reason but im not sure its the same issue of yours.

• 
  @paulohumberto96365 жыл бұрын

  Boa noite! Vc vende a placa do detector gpx 500?

• 
  @cliffchism91875 жыл бұрын

  Pencil eraser is also great for cleaning contacts if you don't have any contact cleaner. Just be sure to blow it outa little if any rubber comes off.

• 
  @mickrohan28186 жыл бұрын

  I just fixed the cruise control on my 2012 GC by following this video. Seems to be working fine now. Thanks for putting it up. The only problem I had was disconnecting the air bag leads. I hadn't seen this type of termination before, but I looked it up on another youtube video and I was on my way.

• 
  @michaelfaunve84756 жыл бұрын

  Nice video - I ran into the same problem with my 2011 GC and your video showed how big of a job I was getting into. Took my time and finished in one hour - and so far so good.

• 
  @silvanahebert30696 жыл бұрын

  same here

• 
  @ginjiguts7 жыл бұрын

  awesome! Thank you this worked for me too!

• 
  @MetalDetectorscom7 жыл бұрын

  Glad to hear that

• 
  @jefflevy52794 жыл бұрын

  What does this fix? What was issue to begin with?

• 
  @sierraridgereaper7 жыл бұрын

  Nice work. What coil is that you are using and what are its specs, 300/350uH? what R (ohms)?. It looks like a fairly large coil. How far was your nugget from the coil surface in the air test?, it is kind of hard to tell from the angle. I get about 5 inches with a 1.2 gram nugget and right about 3 inches on a .45 gram (8 grain) nugget with my 7-1/2in litz wound 3dss coil. Thanks for posting the vid, nice to see someone do a step by step vid with scope shots.

• 
  @MetalDetectorscom7 жыл бұрын

  Hi glad you enjoyed it. Coil is Nugget Finder 14x9 litz wound about 340uH and 0.4 ohms. Depth would have been around 4-5" from memory. Nugget would be 1-2 gms sponge type in quartz.

• 
  @AD83137 жыл бұрын

  Sumptuously!!! like!

• 
  @AD83137 жыл бұрын

  Very interesting experiment!!! Like!

• 
  @PommyDownUnder8 жыл бұрын

  Interesting, Cheers for that.

• 
  @rocketaroo8 жыл бұрын

  not alot of difference between tx2 and 3.But a big difference between tx1 and 2.