Did you place any additional resistors on the side of the capacitor? Since I see that other boards of the DCB1104 model do not have those resistors.
@uncanalmas58242 күн бұрын
Exactly the D3 and R7
@apsubmittedtoGod2 күн бұрын
@@uncanalmas5824 no, i didn't, D3, R7 and the capacitor there are snubber circuit to block voltage spikes coming from transformer, 1:43
@carlosreyes-ko9im2 күн бұрын
Hello. Sorry. I have the same charger. The IC 3113 is ok but does not appear 5 volts. Also oscilator circuit IC P1216 was replaced but the charger does not work. I think first I should have stand by en then the main voltaje but I do not find the problem. Thanks for your answer.
@apsubmittedtoGod2 күн бұрын
do the LEDs turn on when you plug it in?
@carlosreyes-ko9im2 күн бұрын
@@apsubmittedtoGod no. Nothing happend. Only appear 165 VDC in the mains capacitors.
@apsubmittedtoGod2 күн бұрын
@@carlosreyes-ko9im so the problem is in the snubber circuit, is it the same exact charger as this in the video?
@carlosreyes-ko9im2 күн бұрын
@@apsubmittedtoGod HI thanks for answer. Modelo charger is DC18RA
@apsubmittedtoGod2 күн бұрын
@@carlosreyes-ko9im did you find any faulty component there?
@logosrema71053 күн бұрын
Твое видео помогло бы если я не нашел номиналы компонентов ранее вдругом месте ,хорошее дело делаешь. Слава Спасителю Иисусу
@uncanalmas58246 күн бұрын
Thank you for your valuable contribution, how long has the charger been working for you?
@apsubmittedtoGod5 күн бұрын
these chargers after conversion work fine, no problems with that
@josephshantimba81247 күн бұрын
Amen
@alexlazaro69138 күн бұрын
Hola puedo hacer lo mismo con un TE 70 q tiene la misma alarma y no enciende??
@apsubmittedtoGod5 күн бұрын
no, it works only with this tool TE76P ATC
@user-2uf2kr2c8 күн бұрын
Hello, mine is blinking red/green but not charging batteries. what could that be? I have 2 with that problem, a DC18RC and a DC18SD. Regards
@apsubmittedtoGod5 күн бұрын
are you sure the batteries are ok?, if yes, then check the mosfet, the big capacitor, and small capacitor near the driving IC
@user-2uf2kr2c5 күн бұрын
@@apsubmittedtoGod Ok. Thx. Picture of the driving IC? Regards
@apsubmittedtoGod5 күн бұрын
@@user-2uf2kr2c 13:13 IC1 the one with 8 pins, and capacitor C12
@user-2uf2kr2c5 күн бұрын
@@apsubmittedtoGod Ok thx. Godbless
@carlosreyes-ko9im4 күн бұрын
Hello. Mine stand by voltaje. K3113 is ok, but dont have 5 volts. Do you know what cold be?
@maxfoundationrepair10 күн бұрын
How to reset a Hilti TE 3000 avr ??
@apsubmittedtoGod5 күн бұрын
you need SRT service reset tool, to do that
@ScrewBot13 күн бұрын
Sir thank you for your research on hilti chargers. I have a charger and when i try to charge the battery, it start charges for 2 seconds and then turns off the fan and does not charge. It stops after 2 seconds. What could be the cause?
@apsubmittedtoGod9 күн бұрын
this is a common issue if the battery is faulty, not the charger
@ScrewBot9 күн бұрын
@@apsubmittedtoGod thank you so much for replying. This shows your dedication to your subscribers..
@sunchoon19 күн бұрын
That's cool
@wiktorkluz37426 күн бұрын
To change calibrration settings u need to srew or unscrew this small philips screw? NOT the golde one?
@apsubmittedtoGod26 күн бұрын
not the golden ones, just the small torx screw that is accessible by just removing the protecting glass
@mouhbibo916627 күн бұрын
مدبيك أقرب فرس رني مسحاقه مزاف من فضلك
@mouhbibo916627 күн бұрын
نعود الكتيب اخي رني حب تكرولي هلتي باش نخدم بيه
@mouhbibo916627 күн бұрын
سمحلي مقدرش نكتب
@mouhbibo916627 күн бұрын
نكري
@mouhbibo916627 күн бұрын
نظريه عليكم
@mouhbibo916627 күн бұрын
اخي سلام انا حب هلتي ايل تقدر نظيره عليكم باش نخدم بيه
@giannysameh3486Ай бұрын
Nothing important
@ClintonDacosta-ge1xsАй бұрын
I have one just like that one bur no lights power going in but nothing out
@apsubmittedtoGodАй бұрын
check stand by circuit, where is the little transformer, check the transistor if it is shorted, or first measure if there is output voltage from that circuit in the capacitor 9:29
@kootvanzyl8250Ай бұрын
Commentary, waste of time.
@sunchoonАй бұрын
Good 👍
@apsubmittedtoGodАй бұрын
Thanks
@muratyaman8772Ай бұрын
Vous êtes d'où ?
@habibsakhn2969Ай бұрын
Ic
@aklekarsarfaraz1929Ай бұрын
Out put voltage not stable
@onasreato9729Ай бұрын
So you just changed the capacitor. What about the temperature? Did the charger's temperature rise?"
@apsubmittedtoGodАй бұрын
no, the charger is designed to be universal with the rest of components, just the main capacitor is different, and sometimes they also put a varistor in parallel for overvoltage protection, that can just be removed without a replace
@onasreato9729Ай бұрын
@@apsubmittedtoGod thank you
@hosseinhalvani31372 ай бұрын
Best quality HILTI❤
@autolancegega5992 ай бұрын
Can you put subtitles
@apsubmittedtoGod2 ай бұрын
for the moment i don't have time for video editing, maybe in the future i will
@roadtrekralph3112 ай бұрын
Thanks. This is exactly was happened to my battery
@todorkpstov35192 ай бұрын
😂😂😂😂😂😂😂😂😂
@todorkpstov35192 ай бұрын
Ти еликтроника ли поправяш или си монтиор
@apsubmittedtoGod2 ай бұрын
монтьор
@parkchinho3 ай бұрын
Have you also tried charging a 60V battery?
@apsubmittedtoGod3 ай бұрын
Not with this one, but there isn't any reason it wouldn't charge it
@FirstLastOne3 ай бұрын
My god is better than your god, and my book says so, so there. Pretty silly sounding, yeah? So is fiction that keeps you in check with fear and guilt.
@apsubmittedtoGod3 ай бұрын
hello! i don't think the highest capacitance cap i put there would be a problem, it is working fine
@aadesina1633 ай бұрын
Thanks very much for this. You re. Champion!!!
@coronelromerop.n.98674 ай бұрын
Hola tengo un cargador de esos. Y enciende el led. Y cuando le coloco la bateria . Prende el abanico y se apaga de una vez. Que tu crees que pueda ser..te agradecería tu ayuda
@francisconotengo34774 ай бұрын
please I need the value of big capacitor
@francisconotengo34774 ай бұрын
Hi, value of big capacitor? thanks
@apsubmittedtoGod4 ай бұрын
82uF, 400v
@mar-tin7024 ай бұрын
Thanks for the tip , I'm reading Quran
@faisalrasool44054 ай бұрын
Bhai es light k sath jo button hota hy red clour wla wo kis lye use hota hy
Пікірлер
Which God and which holy book?
Did you place any additional resistors on the side of the capacitor? Since I see that other boards of the DCB1104 model do not have those resistors.
Exactly the D3 and R7
@@uncanalmas5824 no, i didn't, D3, R7 and the capacitor there are snubber circuit to block voltage spikes coming from transformer, 1:43
Hello. Sorry. I have the same charger. The IC 3113 is ok but does not appear 5 volts. Also oscilator circuit IC P1216 was replaced but the charger does not work. I think first I should have stand by en then the main voltaje but I do not find the problem. Thanks for your answer.
do the LEDs turn on when you plug it in?
@@apsubmittedtoGod no. Nothing happend. Only appear 165 VDC in the mains capacitors.
@@carlosreyes-ko9im so the problem is in the snubber circuit, is it the same exact charger as this in the video?
@@apsubmittedtoGod HI thanks for answer. Modelo charger is DC18RA
@@carlosreyes-ko9im did you find any faulty component there?
Твое видео помогло бы если я не нашел номиналы компонентов ранее вдругом месте ,хорошее дело делаешь. Слава Спасителю Иисусу
Thank you for your valuable contribution, how long has the charger been working for you?
these chargers after conversion work fine, no problems with that
Amen
Hola puedo hacer lo mismo con un TE 70 q tiene la misma alarma y no enciende??
no, it works only with this tool TE76P ATC
Hello, mine is blinking red/green but not charging batteries. what could that be? I have 2 with that problem, a DC18RC and a DC18SD. Regards
are you sure the batteries are ok?, if yes, then check the mosfet, the big capacitor, and small capacitor near the driving IC
@@apsubmittedtoGod Ok. Thx. Picture of the driving IC? Regards
@@user-2uf2kr2c 13:13 IC1 the one with 8 pins, and capacitor C12
@@apsubmittedtoGod Ok thx. Godbless
Hello. Mine stand by voltaje. K3113 is ok, but dont have 5 volts. Do you know what cold be?
How to reset a Hilti TE 3000 avr ??
you need SRT service reset tool, to do that
Sir thank you for your research on hilti chargers. I have a charger and when i try to charge the battery, it start charges for 2 seconds and then turns off the fan and does not charge. It stops after 2 seconds. What could be the cause?
this is a common issue if the battery is faulty, not the charger
@@apsubmittedtoGod thank you so much for replying. This shows your dedication to your subscribers..
That's cool
To change calibrration settings u need to srew or unscrew this small philips screw? NOT the golde one?
not the golden ones, just the small torx screw that is accessible by just removing the protecting glass
مدبيك أقرب فرس رني مسحاقه مزاف من فضلك
نعود الكتيب اخي رني حب تكرولي هلتي باش نخدم بيه
سمحلي مقدرش نكتب
نكري
نظريه عليكم
اخي سلام انا حب هلتي ايل تقدر نظيره عليكم باش نخدم بيه
Nothing important
I have one just like that one bur no lights power going in but nothing out
check stand by circuit, where is the little transformer, check the transistor if it is shorted, or first measure if there is output voltage from that circuit in the capacitor 9:29
Commentary, waste of time.
Good 👍
Thanks
Vous êtes d'où ?
Ic
Out put voltage not stable
So you just changed the capacitor. What about the temperature? Did the charger's temperature rise?"
no, the charger is designed to be universal with the rest of components, just the main capacitor is different, and sometimes they also put a varistor in parallel for overvoltage protection, that can just be removed without a replace
@@apsubmittedtoGod thank you
Best quality HILTI❤
Can you put subtitles
for the moment i don't have time for video editing, maybe in the future i will
Thanks. This is exactly was happened to my battery
😂😂😂😂😂😂😂😂😂
Ти еликтроника ли поправяш или си монтиор
монтьор
Have you also tried charging a 60V battery?
Not with this one, but there isn't any reason it wouldn't charge it
My god is better than your god, and my book says so, so there. Pretty silly sounding, yeah? So is fiction that keeps you in check with fear and guilt.
hello! i don't think the highest capacitance cap i put there would be a problem, it is working fine
Thanks very much for this. You re. Champion!!!
Hola tengo un cargador de esos. Y enciende el led. Y cuando le coloco la bateria . Prende el abanico y se apaga de una vez. Que tu crees que pueda ser..te agradecería tu ayuda
please I need the value of big capacitor
Hi, value of big capacitor? thanks
82uF, 400v
Thanks for the tip , I'm reading Quran
Bhai es light k sath jo button hota hy red clour wla wo kis lye use hota hy
watch the whole video in this channel