Пікірлер

• 
  @OfficialKaygee6 сағат бұрын

  You shouldn’t have had that hair dryer , you didn’t use it effectively 😢

• 
  @NoneMechanic101Сағат бұрын

  @@OfficialKaygee 🤦🏻‍♂️

• 
  @yasirsaifullah7872Күн бұрын

  Nicely done, looks easy enough .. Thanks

• 
  @NoneMechanic10116 сағат бұрын

  @@yasirsaifullah7872 you’re welcome

• 
  @obscenities4073Күн бұрын

  Thank you for this!

• 
  @obscenities4073Күн бұрын

  Thanks!

• 
  @HailMary888Күн бұрын

  OK I believe you. Crazy they don't have one. Wonder why it's not blowing very well.

• 
  @NoneMechanic101Күн бұрын

  👍

• 
  @Marzimus2 күн бұрын

  👍 Figured that was it but the door is a bit stuck. Thanks bro!

• 
  @NoneMechanic1012 күн бұрын

  @@Marzimus You’re welcome

• 
  @OnlineAutoRepairVideos3 күн бұрын

  That little black and gray gun is cool. looks like it's easy to handle.

• 
  @NoneMechanic1013 күн бұрын

  It has been with me for about 6 years.

• 
  @jeroendenny64303 күн бұрын

  I was just curious. I thought we should remove the negative first. By removing the negative cable first eliminates the chance for the positive terminal to throw that spark or arc because the battery is no longer grounded to the car.

• 
  @NoneMechanic1013 күн бұрын

  @@jeroendenny6430 you’re absolutely correct

• 
  @jeroendenny64303 күн бұрын

  @@NoneMechanic101 So, should I remove the negative instead and follow your steps? Do you think it will fix my car problem?

• 
  @Iseekoutthetruth3 күн бұрын

  Easy Peasy.

• 
  @NoneMechanic1013 күн бұрын

  @@Iseekoutthetruth Thanks

• 
  @irisbaez19724 күн бұрын

  How did you find out was the expansion valve? it could be luck of freon or the condenser or evaporator or compressor.

• 
  @NoneMechanic1013 күн бұрын

  @@irisbaez1972 let’s call it luck

• 
  @mrcommonsense90745 күн бұрын

  Are all the sites you go to pay sites ? Thx

• 
  @NoneMechanic1014 күн бұрын

  @@mrcommonsense9074 KZread removed one. I myself didn’t pay.

• 
  @Jmamelia5 күн бұрын

  Hope it works tomorrow!

• 
  @NoneMechanic1015 күн бұрын

  @@Jmamelia 👍🏼

• 
  @sagadsaga5665 күн бұрын

  Can you tell me how my rear vents is blowing hot air but it's cold in the front? What will be the reason?

• 
  @starbasef6 күн бұрын

  WAY TOO MUCH TORQUE! 67-72 LB/FT FOR THE CALIPER BOLTS; 25 LB/FT FOR THE SLIDING PINS. YOU'LL SNAP THE HEAD OFF YOUR WAY, THEN YOU'LL BE UP THE CREEK.

• 
  @NoneMechanic1016 күн бұрын

  Thanks

• 
  @Iseekoutthetruth6 күн бұрын

  Easy Peasy.

• 
  @NoneMechanic1016 күн бұрын

  I appreciate it. Thank you

• 
  @919Babyjoco6 күн бұрын

  💪🏾

• 
  @NoneMechanic1016 күн бұрын

  👍👍

• 
  @trees65437 күн бұрын

  Nice video bro im going to try to do thie later today but is it a 14mm socket or 40? Lol

• 
  @NoneMechanic1016 күн бұрын

  🤦‍♂

• 
  @trees65436 күн бұрын

  @@NoneMechanic101 what mf lol you have an accent but seen other vids and now ik you said 14 lol

• 
  @NoneMechanic1016 күн бұрын

  @@trees6543 Thanks

• 
  @Angelo-ve5sd7 күн бұрын

  Why would a antenna stop working?

• 
  @NoneMechanic1016 күн бұрын

  corrosion or an old antenna

• 
  @tmac_74877 күн бұрын

  Thank-you, that location is real frustrating and stupid ✌🏾

• 
  @NoneMechanic1016 күн бұрын

  They make it hard for we won't do it ourselves.

• 
  @bluebird44248 күн бұрын

  What dies an incomplete recall mean when I look this up at the official site for my car?

• 
  @user-lx4jl4zf8d9 күн бұрын

  You might want to check under the hood left side under the wiper you can see the vent tube going to on the bottom that's where it is on my 2006 town & country base model.

• 
  @NoneMechanic1019 күн бұрын

  Thank you

• 
  @user-lx4jl4zf8d9 күн бұрын

  @@NoneMechanic101 Sorry man gave you some bad information. I took a closer look at my van and is some aftermarket filter that is stuffed in the vent hole on there so no cabin filter

• 
  @NoneMechanic1019 күн бұрын

  @@user-lx4jl4zf8d Thanks

• 
  @Jack-bq2jm9 күн бұрын

  Thanks for the video bro..u a lifesaver all them little details make a huge difference.. never thought i can do the wifes brakes in 30 min very grateful

• 
  @NoneMechanic1019 күн бұрын

  You’re welcome. I appreciate it

• 
  @OnlineAutoRepairVideos10 күн бұрын

  Nice and clear instructions Hector, and congrats on reaching 20,000 SUBSCRIBERS!

• 
  @NoneMechanic1019 күн бұрын

  Thank you. I’m trying to reach you. 👍🏼

• 
  @OnlineAutoRepairVideos9 күн бұрын

  @@NoneMechanic101 If I can do it, you can do it!😁

• 
  @NoneMechanic1019 күн бұрын

  @@OnlineAutoRepairVideos Laterrr

• 
  @OnlineAutoRepairVideos9 күн бұрын

  @@NoneMechanic101 LOL!

• 
  @nunyabuziness842110 күн бұрын

  I've done two of these racks already you don't need to take the battery in all that out😂 all you have to do is cut a 18 mm wrench in half and it will be short enough to get the lines off

• 
  @NoneMechanic10110 күн бұрын

  Thank you

• 
  @djsi38t10 күн бұрын

  Shoud have used them on the car...would like to see how high on the lowest setting....or if these are even a good choice for a car that is low to the ground.15 inches at the lowest is pretty high....I am curious how high the car would be....is it ridiculously high for a car?.

• 
  @NoneMechanic1019 күн бұрын

  When I'm working on a car I have to lifted it more than usual, so at time I used my other jack.

• 
  @Iseekoutthetruth10 күн бұрын

  Easy Peasy.

• 
  @NoneMechanic10110 күн бұрын

  Thank you

• 
  @ferndog146110 күн бұрын

  Thank you , Brother. Always bringing good solid knowledge for those diy young men with kids to save that $$. Dunkin / TimHortons /$tarBucks toast to you.

• 
  @NoneMechanic10110 күн бұрын

  Thank you

• 
  @TeresaEzzell12 күн бұрын

  You are great, awesome. later, after while, crocodile. I have to get a drill like yours, it saves a lot of time, I always use my hands too, so I know the threads are right.

• 
  @NoneMechanic10112 күн бұрын

  Thanks 👍

• 
  @TeresaEzzell12 күн бұрын

  This is the hardest car I have ever seen to change the spark plugs, I will have to follow you one step at a time when doing my tune up, You did a superb job, wonder how much a dealership would charge to do this? I bet too much. thank you so very much.

• 
  @NoneMechanic10112 күн бұрын

  The dealer would charged around 450.00

• 
  @MadeInTexas12 күн бұрын

  You should of removed that $200 dollar plus oxygen sensor.

• 
  @NoneMechanic10112 күн бұрын

  You’re right

• 
  @alfredofregoso341513 күн бұрын

  The manifold or throttle body doesn’t have no gasket?

• 
  @NoneMechanic10113 күн бұрын

  Sorry I don’t remember

• 
  @lp-pf5el14 күн бұрын

  Thank you for both the videos on how to change your rear and front brakes. These videos been such a help. I’m ready to tackling my brakes 😁

• 
  @NoneMechanic10113 күн бұрын

  No problem 👍

• 
  @user-xy1bj6rj6c14 күн бұрын

  When you change brake pads, you need to change the rotor to that rotor. Looks kind of bad so that means your brake pads are out quicker than they’re supposed to be. Because I had mine done. I didn’t do it myself because I didn’t have the proper jack, but the rotors need to be replaced because there are no good and there are warped. I got a feeling yours look warped as well.

• 
  @NoneMechanic10114 күн бұрын

  The owner didn’t want to replace them.

• 
  @ArmandoMartinez-xs9ye14 күн бұрын

  Gracias amigo. Por tu ayuda. Thanks my friend for you help. Have a nivel Day

• 
  @NoneMechanic10114 күн бұрын

  Gracias

• 
  @djgq100715 күн бұрын

  great explaining - very helpful

• 
  @NoneMechanic10115 күн бұрын

  Thank you

• 
  @starlunaconsultingllc660015 күн бұрын

  All I needed to know was where the horn fuse was. Couldn't find a single diagram anywhere that showed it. This was the clearest explanation on the internet. Thank you so much.

• 
  @NoneMechanic10115 күн бұрын

  You're welcome

• 
  @CarlosMartinez-on6pf16 күн бұрын

  Waw! Thank you for your video!

• 
  @NoneMechanic10116 күн бұрын

  You’re welcome

• 
  @joemendez741118 күн бұрын

  Good looking out bro..

• 
  @NoneMechanic10117 күн бұрын

  Thank you

• 
  @bburgess28018 күн бұрын

  Perfect! Thank you!

• 
  @NoneMechanic10118 күн бұрын

  Thank you

• 
  @jeremysuit695718 күн бұрын

  I love that jack I've got the same one. You need the long one piece handle it's the replacement handle they sell it's like $30 an well worth having

• 
  @NoneMechanic10116 күн бұрын

  This Jack is my go to.

• 
  @brendadudley189518 күн бұрын

  🗣Honestly this is the best car maintenance video I have ever seen and believe me I am an auto mechanic from the 70’s. You got right to the point without a drawn out conversation.keep up the good work for me this one deserves a gold cup💯🏆❣️👍🏽

• 
  @NoneMechanic10117 күн бұрын

  Thank you

• 
  @cfrosties7318 күн бұрын

  mine don't click only makes a running noise but not start something to do with selinoind???

• 
  @NoneMechanic10118 күн бұрын

  It can be

• 
  @OnlineAutoRepairVideos19 күн бұрын

  Cool Hector!

• 
  @NoneMechanic10119 күн бұрын

  Thanks

• 
  @Iseekoutthetruth19 күн бұрын

  Easy Peasy.

• 
  @NoneMechanic10119 күн бұрын

  Thank you

• 
  @rellyrell6519 күн бұрын

  What’s the site to go in

• 
  @NoneMechanic10119 күн бұрын

  KZread removed it

• 
  @barrybaker967720 күн бұрын

  Be a whole lot easier if you would turn the wheel right or left depending on which side you are working on

• 
  @NoneMechanic10120 күн бұрын

  Thank you

• 
  @jackhandy103920 күн бұрын

  Thanks for the video freind. Keep it going my man.

• 
  @NoneMechanic10120 күн бұрын

  Thank you.

• 
  @toddgittins569222 күн бұрын

  Listen to that 6hp!!

• 
  @NoneMechanic10122 күн бұрын

  ?

• 
  @alexhurlbut317922 күн бұрын

  So your wife

• 
  @NoneMechanic10122 күн бұрын

  My best friend.

• 
  @OnlineAutoRepairVideos22 күн бұрын

  LOL, me and Silvia loved this video Hector! Now when can we see you take it for a ride? LOL!!

• 
  @NoneMechanic10122 күн бұрын

  I’m not getting on it. My bones tells me not to do it😂

• 
  @OnlineAutoRepairVideos22 күн бұрын

  @@NoneMechanic101 LOL!