Thanks Mick, useful test, now I need to find an immovable object, club house wall maybe………😂
@fixityourself1112 күн бұрын
@@michaelsaville7485 👍🍺
@WrenlyMari10 күн бұрын
Sir is it safe to wash the batteries with water, doesn't it cause a short circuit? Thank you for your tutorials...
@fixityourself1112 күн бұрын
@@WrenlyMari absolutely safe .
@farhozz16 күн бұрын
I have a zapi controller from pallet mover, can it be used on a brushed permanent magnet motor,sir ?
@fixityourself11115 күн бұрын
Im sorry mate but im not sure on that
@TaylorTaylor-yi4qdАй бұрын
Just rebuilt one on my daughter’s G29. Got to take it back out. I think the armature is bad. The cart isn’t moving at all. The A1 wire is getting hot when pedal is pressed down.
@fixityourself111Ай бұрын
Pull that motor and check / sand the armature🍺🍺👍
@TaylorTaylor-yi4qdАй бұрын
@@fixityourself111 I sanded it when I had it apart but it is in really bad shape.
@fixityourself111Ай бұрын
Ah ok If the ribs are almost gone then it may need replacing mate.
@TaylorTaylor-yi4qdАй бұрын
@@fixityourself111 I’m going to look into an upgraded motor for it. Thank you for the videos and help. Cheers from middle Georgia in USA. 🍻
@rtryon24Ай бұрын
Do you have a link to the input shaft bumper so I can make sure I get the correct part?
@fixityourself111Ай бұрын
I dont have a click link mate but this is the part number for yamaha Jh7-H1829-00 Youll find that most carts us the same bumper .
Пікірлер
Thanks Mick, useful test, now I need to find an immovable object, club house wall maybe………😂
@@michaelsaville7485 👍🍺
Sir is it safe to wash the batteries with water, doesn't it cause a short circuit? Thank you for your tutorials...
@@WrenlyMari absolutely safe .
I have a zapi controller from pallet mover, can it be used on a brushed permanent magnet motor,sir ?
Im sorry mate but im not sure on that
Just rebuilt one on my daughter’s G29. Got to take it back out. I think the armature is bad. The cart isn’t moving at all. The A1 wire is getting hot when pedal is pressed down.
Pull that motor and check / sand the armature🍺🍺👍
@@fixityourself111 I sanded it when I had it apart but it is in really bad shape.
Ah ok If the ribs are almost gone then it may need replacing mate.
@@fixityourself111 I’m going to look into an upgraded motor for it. Thank you for the videos and help. Cheers from middle Georgia in USA. 🍻
Do you have a link to the input shaft bumper so I can make sure I get the correct part?
I dont have a click link mate but this is the part number for yamaha Jh7-H1829-00 Youll find that most carts us the same bumper .