Пікірлер

  • @ginaladner1
    @ginaladner16 сағат бұрын

    Thanks to you I think I have finally found my next washer(after about a hundred videos🤣)

  • @riraider123
    @riraider1236 күн бұрын

    Did your old one light up? Mine lights up but no flame

  • @BatBrakesBones
    @BatBrakesBones5 күн бұрын

    Replace it it's degraded

  • @lindawright4447
    @lindawright44477 күн бұрын

    what a useless video

  • @Nedinho23
    @Nedinho2313 күн бұрын

    Did it work?

  • @BatBrakesBones
    @BatBrakesBones13 күн бұрын

    No

  • @Nedinho23
    @Nedinho2313 күн бұрын

    @@BatBrakesBones did u end up replacing compressor?

  • @protroll25
    @protroll2521 күн бұрын

    This was zero percent helpful

  • @BatBrakesBones
    @BatBrakesBones21 күн бұрын

    I was making artsies on Instagram

  • @karlonbaker8953
    @karlonbaker895321 күн бұрын

    I wish you would have shown the whole process videos like this are useless

  • @winfree95
    @winfree9524 күн бұрын

    How'd you get the back panel off?

  • @Mudo94
    @Mudo9425 күн бұрын

    My whirlpool model GD5RVAXVY05 has water at the bottom of freezer frozen… and water leaking under it. Clogged line? I seen someone replace what looked like a washer as well

  • @HeatherVOcarina
    @HeatherVOcarina26 күн бұрын

    It doesn’t fill with water for rinse cycle so clothes don’t rinse properly

  • @darkdeath2529
    @darkdeath252927 күн бұрын

    If you only wanted to idle w/out lights just start the car with E-brake on

  • @mensdailyadviceencouragement
    @mensdailyadviceencouragement27 күн бұрын

    Interesting. Wish there's a Way to test it and Verify on Video

  • @chobun6671
    @chobun667127 күн бұрын

    What is the part number?

  • @Ilovewashers18
    @Ilovewashers1828 күн бұрын

    8:08 then ai can come and.. come over and wipe your butt idk fucking know😂😂😂😂😂

  • @usouljah297
    @usouljah297Ай бұрын

    Where did you get the replacement part?

  • @YouTubeabduazizov.
    @YouTubeabduazizov.Ай бұрын

    Luger

  • @andrewcao6135
    @andrewcao6135Ай бұрын

    How does melting all that ice help with sending air to the fresh food section?

  • @BatBrakesBones
    @BatBrakesBonesАй бұрын

    Air circulation. Think of UAPs and the coriolis effect over Antarctica. Range rovers.

  • @dxtrdxtr4457
    @dxtrdxtr4457Ай бұрын

    Does it continue to spin if you open the lid? Or does it stop?

  • @dxtrdxtr4457
    @dxtrdxtr4457Ай бұрын

    I saw it... it stopped. Thanks.

  • @dxtrdxtr4457
    @dxtrdxtr4457Ай бұрын

    I want one that continues to spin even when lid is open

  • @jeromedavis8575
    @jeromedavis8575Ай бұрын

    Stupid crap!

  • @tiffanypalmer3804
    @tiffanypalmer3804Ай бұрын

    I appreciate your honest review & actually showing how the washer works. THANK YOU!

  • @Keoughan
    @KeoughanАй бұрын

    What was the point of this? Complete waste of time.

  • @BatBrakesBones
    @BatBrakesBonesАй бұрын

    waist of time* the universal equator..

  • @KeithsTVHD1
    @KeithsTVHD1Ай бұрын

    Nice video, i have this washer being delivered 2morrow.

  • @rolandeholland1996
    @rolandeholland1996Ай бұрын

    How do you fix the issue?

  • @erickmuniz1960
    @erickmuniz1960Ай бұрын

    Please to help español

  • @BoredRock112
    @BoredRock112Ай бұрын

    The drawer says softener but the agitator has a softener despenser 😂😂😂

  • @BatBrakesBones
    @BatBrakesBonesАй бұрын

    You put the softer ones in the drawer..

  • @Azis.dikudusha
    @Azis.dikudushaАй бұрын

    I have same issue. Is the hook tube at the bottom removable by hand to clean out ?

  • @smilinacha
    @smilinachaАй бұрын

    How is this☝️supposed to be HELPful?!?!!??!

  • @BatBrakesBones
    @BatBrakesBonesАй бұрын

    Pretty flowers

  • @smilinacha
    @smilinachaАй бұрын

    @@BatBrakesBones - exactly

  • @paulocaillile7009
    @paulocaillile7009Ай бұрын

    Hahahahaha

  • @WineJ57
    @WineJ57Ай бұрын

    Very nice. Whats that tool you used to remove the metal clamp by the springs?

  • @BatBrakesBones
    @BatBrakesBonesАй бұрын

    Just look up Whirlpool gasket ring removal tool on Amazon or something like that you'll find it

  • @jonbontobi504
    @jonbontobi5042 ай бұрын

    Can it handle a Cal King Comforter ???🤔

  • @jonbontobi504
    @jonbontobi5042 ай бұрын

    Im actually getting this washer! I like your honest, funny style! 😂

  • @BatBrakesBones
    @BatBrakesBones2 ай бұрын

    That water level feature 👍 quick wash everything

  • @alexiscastro1148
    @alexiscastro11482 ай бұрын

    Como se programa esta labadora oiga

  • @BatBrakesBones
    @BatBrakesBones2 ай бұрын

    Eso yo lo encontré en el manual. Buscalo Online con el Model #

  • @checkrockbasketball5724
    @checkrockbasketball57242 ай бұрын

    How do I get to that do I have to take the door and everything off or is it from the back

  • @BatBrakesBones
    @BatBrakesBones2 ай бұрын

    The blower wheel is in the front bottom left you got to take the front off

  • @OldFordTaurus
    @OldFordTaurus2 ай бұрын

    There’s no clothes in it? The machines weigh the clothes and go from there

  • @benjaminschultz2582
    @benjaminschultz25822 ай бұрын

    Was looking at the GTW465ASNWW, GTW485ASWWB, and GTW585BSVWS. It's just like the GTW465ASNWW. kzread.info/dash/bejne/Z4qfyKWDlc-ykpc.htmlsi=jjX1OWELOLkkAgf7&t=495 Thanks.

  • @jeffhickox
    @jeffhickox2 ай бұрын

    How much to repair?

  • @Kevin-tx4qp
    @Kevin-tx4qp2 ай бұрын

    ? and??

  • @AmayraniRios-jm7gf
    @AmayraniRios-jm7gf2 ай бұрын

    So you just open the back plate and thaw out the coils? Where would the melted water drain to?

  • @BatBrakesBones
    @BatBrakesBones2 ай бұрын

    There's a drain tube in the back that's clogged. That's the root of the issue. Melt the ice then clear the clog.

  • @AmayraniRios-jm7gf
    @AmayraniRios-jm7gf2 ай бұрын

    @@BatBrakesBones all done, everything seems to be working now thank you for the help

  • @yt_crabby3743
    @yt_crabby374321 күн бұрын

    @@BatBrakesBonesin what part i have the same problem just now

  • @LindaVan-rc2zy
    @LindaVan-rc2zy2 ай бұрын

    All I wanted to see was it agitating. Still not sure because the lid was closed and it was hard to see. That's the most important thing is to see if the clothes are actually cleaning or barely moving. Unfortunately no other videos on this machine. Maybe you could do the video again with the lid open. Thank you 4/14/2024

  • @benjaminschultz2582
    @benjaminschultz25822 ай бұрын

    Watch a video of a similar model in the line, which should be exactly the same. kzread.info/dash/bejne/Z4qfyKWDlc-ykpc.htmlsi=Zq7ck_HauKpx3uM0

  • @louisbaiani6262
    @louisbaiani62622 ай бұрын

    Our exact same model glitched as well. Try disconnecting power for a long time.

  • @louisbaiani6262
    @louisbaiani62622 ай бұрын

    I am having the same issue I had to disconnect from the power outlet. I used mixed load with deep fill and it was acting as if it was on normal eco. Looked like 3 inches of water

  • @johnwilliams3075
    @johnwilliams307523 күн бұрын

    @louisbaiani6262 My new machine literally just did this yesterday, on the second load I was running, right after the first one (and a few dozen in the weeks before that) worked absolutely perfectly. Nothing would get it out of this behavior except unplugging it for a bit, which brought it back to normal. Did Maytag ever come back with a more durable solution for this? It feels like a software / firmware / sensor glitch on the control board of some kind since the PC type "Have you tried rebooting it?" process actually worked.

  • @Greg-vq9tu
    @Greg-vq9tu2 ай бұрын

    Thanks so much! Just bought this washer today. Had the prior model this replaced and lasted many years. Big fan of GE washers. It was a toss up between this or a LG.

  • @BatBrakesBones
    @BatBrakesBones2 ай бұрын

    Don't buy LG. It's a premium brand like Samsung. They're premium price with overpriced parts. They look better in your house though. They're pretty. But it's all the same. Even ge.

  • @Californer
    @Californer2 ай бұрын

    Thermador is SHITY appliance🤮🤮🤮🤮

  • @mike289homebuilt5
    @mike289homebuilt53 ай бұрын

    Lol, looks newer. Mine had two bad clutches.

  • @omarpimentel1047
    @omarpimentel10473 ай бұрын

    How do you like it a year later

  • @BatBrakesBones
    @BatBrakesBones3 ай бұрын

    Knob stem is cheap. Could break at any time. Then I believe you have to buy the entire board. Don't like the engineering/design behind the knob/stem/board. I haven't confirmed if you're going to need an entire new control board if the stem breaks but if you do that's a bummer control boards are one of the most expensive Parts on a washer. The Speed Queen tc5 is still the next option for me. It's a 1500 washer but I live with seven people.

  • @omarpimentel1047
    @omarpimentel10473 ай бұрын

    @@BatBrakesBones thanks yea I'm debating with the tc5 or tr7

  • @alejandroarroyo-mf9hr
    @alejandroarroyo-mf9hr3 ай бұрын

    You are amazing what a class I just got done….useless.

  • @KR-ej1ns
    @KR-ej1ns3 ай бұрын

    Washer won’t fill or agitate

  • @BatBrakesBones
    @BatBrakesBones3 ай бұрын

    Buy a $1t500 speed Queen

  • @aallemant2011
    @aallemant20113 ай бұрын

    Wtf aren’t you supposed to show us some work done on it? Or how to replace something? You’re a clown

  • @jd2799
    @jd27993 ай бұрын

    Did you purchase it from Maytag direct? What’s the model number on the machine you purchased? The true Maytag Commercial Washer can only be ordered through Maytag direct and it has a full 5 year warranty. More disinformation.

  • @thirty2able
    @thirty2able3 ай бұрын

    Well I don't know if it will fill water right to the top cause you stopped it but it definitely beats the lemon lid locked Maytag I bought not aware that the government had got control of the water you can use to clean your clothes making it impossible with some machines like my disaster, to do the job. I love your attitude. You remind me of me. Thanks for the video. I enjoyed it

  • @lisavillaroel5952
    @lisavillaroel59523 ай бұрын

    Worst video ever you don’t show us anything. How do you take off the latch part if your door is locked? 🙄

  • @BatBrakesBones
    @BatBrakesBones3 ай бұрын

    Would you like to schedule a service call? I'll show you..

  • @diggitydo41
    @diggitydo413 ай бұрын

    Replaced mine and it broke 1 month later. Buy OEM!!